Sabre Tools 5/8 Inch SDS MAX Ground Rod Driver Bit for use with Rotary Hammer Drill(5/8" Ground Rod Driver)
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For Sabre Tools 5/8 Inch SDS MAX Ground Rod Driver Bit for use with Rotary Hammer Drill(5/8" Ground Rod Driver)
A rock will eventually hit them. After that, a breakthrough. I can install 10 pieces of rebar that are 4' long in five minutes. Then, spend hours driving one rod 3' deep, hitting a rock, and then throwing up because you are incapable of pushing through it, or spend all day in the trenches pushing one rod 3' deep and not breaking through it.
Since I ordered and received this bit back in February, I did not need The first time I tried to insert it into my SDS, it would not pop-up This page shows the Max Roto product lines I am hammer. My observation of how the shank was machining has led me to conclude that there are only two keyways on it. It is based on the The bit must be held in place with three keyways and two grooves made for ball bearings. During my attempts to insert the bit into the chuck, I was unable to do so as the right machining was not done properly. Upon attempting to use it, I realized it had gone wrong, but it was too late for me to return it. You should inspect the fit of the bit as soon as you receive it! The following feedback has been revised It was offered to me that the seller would refund or replace my order. The replacement was a good choice for me, so now all is well. I was told that the one I received was a manufacturer defect and they've contacted me to fix it.
We used it to put rebar through when the SDS plus one would not Does exactly what it is supposed to do and is perfectly compatible with SDS Max. This is a very fair price and this is a very solid bit.
Thus far, we have driven two 8 ft ground rods. I drove roughly 2 minutes to drive to Y and 5 minutes to drive to RA, but that was likely due to different In case it matters, I stored it in the plastic case it came in instead of the paper bag it was shipped in. It was damp in the tool, which caused some rust to form while it wasn't.
Good quality at that price.
This product does what it says. It can be used to drive in rebar without any problems. Excellent! I strongly recommend it!.
It fits the steel rods well.
You can get one at a fraction of the price of a tool from the commercial tool manufacturer in Germany.