Bosch HC2040 1/4 In. x 4 In. SDS-plus Bulldog Rotary Hammer Bit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is a pleasure to answer SDS for the HC2000 Having a working length of 2, plus Bit has a 2 byte capacity. In the 4 and the 0, there is no significance. Bits of 0" length have an overall size of 0.5". You can reach us at 1-888-450-3838 if you need further assistance Dial 877-777 ABOUT BOSCH 99 Dial 877-777 Two hundred six Monday to Friday The following days are Fridays 7A to 10A 7 p.m. Central Standard Time.
In a way. If you try it, there are slots and ridges in the bit that make it difficult to fit into a standard drill squarely because it is an SDS bit. Would it be possible for you to It is true. Instead of using a standard 5/32" drill bit, should you use a standard 5/32" bit? It's probably true.
The connector will fit any chuck rotor hammer with SDS chuck.
Selected User Reviews For Bosch HC2040 1/4 In. x 4 In. SDS-plus Bulldog Rotary Hammer Bit
I borrowed a friend's hammer drill (which I thought was much more serious than I was) and bought 2 of these bits, assuming that I would break one while I was working. We didn't happen to do this I did not have any problems with the bit - it worked superbly. It is easy and fast to drill into concrete. Any drill bit requiring a SDS fitting that is drilling into concrete, I recommend this bit.
As a result of reading the reviews, I decided that this would be the perfect product A 1" deep hole had to be drilled into the brick. My attempt at gaining one eighth of an inch in the first hole took several attempts using a regular drill and a hammer drill. recall the last time I left a negative review, but this bit performed similarly to a wood bit when drilling brick. There could be a defect in it. Would be a.
This bit allows me to drill holes for tapcon screws in concrete blocks. Compared to the screws that come with the tapcon bit, the tapcon bit is absolutely As long as I use this bit with my inexpensive SDS hammer drill, drilling holes for screws is easy. Due to my lack of professional experience, I am unlikely to wear the bit out. The block did not show any signs of wear after drilling about 20 holes.
Don't forget boys and girls, Amazon also has shorties in tapcon sizes! Buy a 6-pack when you can get a 2-pack Putting in a 2-in drill bit when you only have a 1-in drill bit Would you like to join Tapcon?.
An SDS-based system Added Bit to the end. The bit is good quality and I use it frequently for drilling holes in concrete walls for 1/4" plastic conical anchors used for mounting control boards and electrical boxes. Using this bit with my cordless SDS-I makes it much easier to fit into tight areas. It is only 4" long overall and 2" long usable A rotary hammer is also included.
is not the right measurement. Please see https//www. nbsp 2 inches is not a 4 inch bit. There are five inches long
four inches with the SD
I am not sure if this is how they are usually sold, but it seems like a scam.
It makes holes that are easy to clean. Once you drill past the flutes, the drill bit binds a little. Anchor kits were mostly what I used this for.
After repeated use, there are no problems with dulling.