Rev-A-Shelf 6562-14-11-52 14 Inch Wide Tip-Out Accessory Organizer Tray with Heavy Duty Tab Stops, White, 2 Pack
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It measures 14 inches long, 2 1/2 inches wide, and 3 3/4 inches tall.
I'm not sure what I'm saying. These have been in my possession for a number of years. It's always a good idea to have a backup in case the first one fails.
Thank you for reaching out to us with your query. Yes, the contents of the product are exactly as they appear in the listing. (2) Trays in white with mounting hardware
The screw holes are 12 inches apart, the try is 14 inches, and the tabs are 15 inches long from end to end.
Selected User Reviews For Rev-A-Shelf 6562-14-11-52 14 Inch Wide Tip-Out Accessory Organizer Tray with Heavy Duty Tab Stops, White, 2 Pack
The drawer front is not held in place by the shelf. Just to keep the drawer from falling out, I had to attach a magnetic latch. There are no instructions included, so you'll have to figure it out on your own. Overall, I wish it had a better support system to keep the drawer in place and prevent it from falling out.
These are 14" as others have stated, despite the fact that the picture makes it appear that one is smaller than the other. Both were in perfect condition when they arrived and were exactly what I needed. They didn't come with screws, which isn't a big deal, but keep in mind that you'll need to either reuse old ones (if these are replacing other trays) or have new ones on hand.
It was fine because it was the only size I required. I wish I could have found a higher-quality one in that width.
I bought two of these trays to go inside the front panel of a kitchen cabinet. This is the kitchen sink cabinet's panel. In front of the sink, this cabinet panel is at waist level. It usually just fills in the space above the doors that access the space beneath the sink in the cabinet front, in front of the sink. The cabinet front panel will tilt out if hinges are installed on it. Kitchen sponges, dish brushes, steel wool pad, and other items can be stored in these trays if they are screwed to the inside of the cabinet panel. I purchased the hinges and trays and completed the conversion. It wasn't difficult, but it did take some time to get everything right. "Measure twice, drill once" is a good rule of thumb. Ideally, so that the cabinet panel can close without the trays hitting the top of the cabinet opening or preventing the panel from closing because the trays hit the bottom of the opening; low enough on the panel so that the trays actually store stuff; and shallow enough so that the holes don't go through the cabinet front piece. The installation went off without a hitch and without any extra holes or mishaps because it was done with care and caution. I'm looking forward to clearing the sponges and brushes that have accumulated on the top of the sink and counter.
It was fairly simple to set up. To make it sit properly, I had to cut off the inner tabs. However, they aren't required in any case. It does exactly what I expected it to do.
These were purchased to replace the trays that I had previously purchased. Be gentle with the tab stop ends because they are easily broken. I'd been looking for these trays for so long that I'd given up hope until I came across them on Amazon! I received them today and had them both installed in a matter of minutes; they are a perfect fit, and I am thrilled to have discovered them. Thanks !.
We had trays that needed to be replaced on our dropout shelf in front of the kitchen sink. I found these and we were overjoyed when they arrived. They were simple to install and fit perfectly. We wanted something that was easy to wipe away and that was exactly what we got.