Stainless Steel Quick Disconnect Set Female Barb+Male MPT1/2 inch
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Five to ten, I would say
There are two reasons why no. It is larger in size than the brewing quick disconnect, and it is also larger in size than the pressure gauge. Using a pressure washer that works in the 2500 range With this brewing coupler you can get about 5 to 3000 psi and the pressure ranges from 3000 psi to 3000 psi There are 15 pounds per square inch. Pressure washer pressures will rip out the "O" ring in the brewing coupler if it is subjected to high pressure
Selected User Reviews For Stainless Steel Quick Disconnect Set Female Barb+Male MPT1/2 inch
In my case, I have been using 1/2" FPT hose barbs to connect the inlet hoses to the pumps for quite some time. This setup has never pleased me, since the inlet hoses are always connected, even when the unit is stored. When I set up the initial system, I ran out of quick disconnects and just did what I could. As soon as I pulled the trigger on these disconnects, after just one brew day, I realized how much I appreciated that decision. In contrast to tri-point disconnects, quick disconnects (disconnects that happen quickly instead of After those tubes dried out I was able to hang them up to drain and air dry, as I had always wanted to do. As far as the product itself is concerned, it's well-designed I can tell that the build quality is high from everything I have seen. just have a solid, well-constructed feel to them. As long as they work, everything is fine. It is highly recommended, especially for the price. Other quick disconnect solutions can often be much more expensive.
Since a year ago, I have been using these connectors often and have found that they are reliable and well-made. You can also use a camera- It is important to soak them by soaking to remove any mash or wort from the moveable ring as the sugar can cause the device to stick. The Quick Disconnects are much more user-friendly than the lock connectors. They can be used with one hand frequently.
Works with any brand of receiver and creates a tight seal whether it's to be used for It is a great product to recommend to anyone using quick-release technology There are many components to the release.
I love how much easier it is.
The only heat source you need for your brewing needs. No leaks have been reported, and replumbing of the brewery is quick and easy with this system.
The disconnect look good and worked.
I am happy with how things are going so far. This was bought for my camlock part of my brewery to connect to the new 1" heat exchanger I bought. Triclamp of 5 inches in diameter. The system is flawless, no leaks have been detected.
Quick connects made of stainless steel at a low cost.