Anvil - ANVDipTube Dip Tube
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Each piece of paper is divided into two.
checked the Amazon page for this item as well as the Anvil website, and neither site specifies that it is actually made of steel designed for use in breweries. Although the majority of homebrew these days is stainless steel, it's still good to be sure even though almost all homebrew nowadays is made from stainless steel. I think it is great that you asked, and the answer you got is "yes!"
You cannot rotate it from the outside of the kettle, only from the inside
With this dip tube you can use the Anvil Kettle Strainer - it is specifically designed to work with this. Tubes could be used alone, but they would not offer the benefit of keeping hops out of them and keeping them from plugging All of them are used by me- The ingredients are combined in a kettle that holds 8 gallons. Its 1/2" NPT size allows it to be threaded or adapted to any 1/2" NPT bulkhead, whether welded or weldless, the difference makes no difference to the fitting.
Selected User Reviews For Anvil - ANVDipTube Dip Tube
It fits my GasOne 8 gallon boil pot perfectly, and I highly recommend it. The female NPT (FPT) thread is standard. The level of the remaining liquid can be controlled by swiveling to the side. There is a 3/16" gap between the hose outlet and the pot's bottom when the outlet is kept below the pot's bottom or a pump is used, which allows about a cup of liquid to drain out when the outlet is correctly positioned vertically. If you are seeking a good dip tube, this one is the one to get. However, there is no decline As it was rated, I thought its price was just a little bit too.
This allows me to collect more wort from the kettle without having to remove the trub. A lower degree of waste beer and reduced trub loss means less grain to be purchased per batch of beer.
It was even better after I added more pipe tape and switched the o-rings A new one will be provided if you ring. There is no way to pass the bulkhead for it to drain. Upon reconfiguring my bulkhead assembly, I even included new hardware. The hoses had tape on all of the fittings, so there must be a small air leak somewhere. I would have given it a five if it had done everything I had hoped it would do.
When the thread was manufactured, a sharp knife-like piece was left in the thread that was not removed/filed down. The file was filed down by me. The only thing I can hope for now is that this will not rust out as all the other reviews suggest.
The internal rubber gasket became loose during the boil. As a result, the tube became loose, which prevented it from drawing from the bottom of the kettle correctly. Anvil did not make the fitting to which I attached it. Anvil fittings may be the only ones that are compatible with this dip tube.
It was bought for someone who didn't have access to it I have an Anvil kettle and it works great! As a result, I have only a single cup of wort left where as before I had nearly 6 cups.
We found it rusty when we got there, so we weren't happy.
I have used it with a Bayou Classic 15 gallon boil kettle and it works.