Summitlink V2 Tint Case Dual Fans for Stratux ADS-B Kit Fits AHRS Module and GPYes
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As long as the chip is connected to the fan, it will cycle on and off You can connect it to the USB port at the end of the Raspberry Pi board to make it run indefinitely In order to make use of the AHRS chip, it is recommended to connect the fan to
Alternatively, the second fan should have a USB connection, so you can just plug it in any open USB port.
Put both sides near the tabs together and squeeze them together.
Selected User Reviews For Summitlink V2 Tint Case Dual Fans for Stratux ADS-B Kit Fits AHRS Module and GPYes
In addition to this case (not of this type), I have purchased a number of other cases for the ADS-2000 There is a B in the receiver position. With the case, it is easy for the components to be inserted. The component can be placed either on the standard tripod mount or on In addition to the AHRS, the USB connector for the second fan and the USB connector for the external GPS unit are located in this case.
I had a great time building this. At first I was concerned that it did not have screws until I read other reviews and info and discovered that the screws aren't needed. The process of assembling this was straightforward. The product made assembling ADSB receivers for fellow members of the EAA and other pilots at the airport much easier, not that assembling this is hard.
I would and will buy another one if the price is right.
I thought the design was poor. A memory chip will be broken if you do not handle it very carefully while installing the board. Best to leave the chip out until the board has been installed. It's not necessary to have two fans since the USB connector on one of them is too large to fit if you're using GPS.