SPARIN 2 Pack Screen Protector Compatible with iPad 6th Generation/iPad Pro 9.7, Tempered Glass Screen Protector
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
In fact, yes. This screen protector went on more easily than the first one I bought, since I had bought the single pack of screen protectors before.
There is no interference between the magnetic iPad cover and the screen protector. It may be that you accidentally purchased an iPad cover older than the one that supported sleep/wake? If you have an older iPad which does not have this feature, you can use it. The problem that may be causing the issue is purely a guess on my part.
There are two screen protectors in the package, but I'm not sure about them. On their website you can find more information.
Selected User Reviews For SPARIN 2 Pack Screen Protector Compatible with iPad 6th Generation/iPad Pro 9.7, Tempered Glass Screen Protector
It has been a pretty satisfactory experience for me. To make the installation easier, they also send you a link to a video to watch.
The first time I installed the protector without the case, it didn't work. There was no problem with it. It seems that when I put the case on, the case overlap lifted the protector, and the adhesive on the glass began to creep To remove the glass I removed the screws and the bottom of the window As far as my case is concerned, I have left it there. After removing any more dust from the iPad with the tape, I once again cleaned it. Ensure that you cover all the iPad's surface with tape. A perfectly centered Sparin is obtained once it has been lowered down to its lowest point. Watching the adhesive slowly spread across the screen was all I could do as I let go. As part of the process, I spread the microfiber cloth across the entire screen and around all edges with a credit card. It does not contain any trapped particles. Using this method if you have a case, first put it on, then drop the protector with the film still on, and see if it fits. It would be best not to even try to install it if the Sparin couldn't fit between your case lips. You will cause the glass to lift up from your case. As long as the lip fits between your case and the cover, you can install it while the case is still While a video shows how to apply Sparin using tape hinges, it is not as easy as it appears.
It amazes me how good the reviews Despite using both iPad protectors, I ended up using only one. Using the dust remover left lines of glue on the screen, which needed to be removed with the cloth in order to leave no glue, which then had to be removed with the dust remover, which did leave Can you see where I'm going with this? I went to work this A lot of frustration resulted from it. As a result, I have an iPad screen that's 90% perfect. While there are some glue marks left on the screen, they're not as noticeable as they were unless the screen brightness is below 15%. Dust creates an air pocket that is so obnoxiously obvious that you can observe it from space, but it is better than dust because even a tiny bit of it generates an air pocket. In summary, the protector will provide peace of mind, but the process of installing it is awful. My only wish is to have gotten an application kit that you can wet apply. I received another set of protectors from the company. Edit The company reached out to me and sent me another set. The manner in which they handled it was very polite. Truth be told, I am editing my review partially because they have been sending me messages asking me to update it since I received the replacements. So, I guess. There are many. There are messages.
I'd like to thank them for their concern, so the star rating has been changed to five stars, but the title stays the same because, seriously, I've received.