AC Infinity MULTIFAN S7-P, Quiet Dual 120mm AC-Powered Fan with Speed Control, UL-Certified for Receiver DVR Playstation Xbox Component Cooling

Fan power is AC and USB. It is quiet, powerful, and can be powered via USB as well. In order to keep my blue screen cool, I needed some cooling agents I've been looking for a way to use this old PS3 cabinet a bit more, IMPORTANT NOTES The *br- You can choose from three speeds. All I use is L (low). I don't need that much power, so I usually keep it on M or H to save This multifan came with an "overclocked" AC adaptor for the USB plug, so I bought it that way. This acceleration allows the fans to run a bit faster than if they were plugged into a regular USB port. Sorry I missed it, but it's definitely fast enough without it. You can choose any speed you like, and you'll always hear the whisper. Across the room, you can barely hear it. In order to control both fans independently, you need to use the switch at the same time. In addition to turning off the fans, the switch also allows you to turn them on and The *br- This can be done by daisy-chaining It would not be necessary to chain a few USB fans from this brand together, except this one is wired with a female USB connector to allow a second set to be attached. In this case, ALL fans are controlled simultaneously through the fan switch control. In total, the two fans have a cable length of 44 inches. The *br- A total of about 6 ft of cable is needed in order to connect the fans to the USB power supply. The *br- If necessary, the rubber feet can be removed from the desk. The first thing you need to do is unscrew the fans, then you can pull the rubber screw out. The *br- Rubber feet are removed along with fan grilles when the rubber feet are removed. There is no need to remove the fans on either side. In case you don't like those grills, you can swap them out with another. Covers and grills of the 120mm kind work just fine for these units. * Br>- Reply to this email if you wish If the fan is oriented in an intake or outtake direction, the power cord should face that direction. You can do that with a groove. The *br- There are about 5 inches of width and 5 inches of height to it. In terms of thickness, the fan measures 1 inch It is an inch longer than it is wide, but the grills and rubber feet add half an More details can be seen in the images. 120mm fans enclose a thick grill, and are through and through. The *br- Whenever you need to rewire these, they are a simple two wire fan with a black (ground) and red (power) cord. At the moment, these keep my temperatures between 81 and 82 degrees. I set the cabinet at 83 degrees, and I set the temperature at 73 degrees There are 75 cents in some days and 75 cents in others. The room temperature usually hovers around 73 degrees, so it does a great job keeping things at a temperature close to what it would be at if left on low power. A brief update In order to add a 120mm AC Infinity fan to this, I bought a separate unit for another application. Whenever you are planning on linking / daisy chaining more fans, the fan / controller with its cable / speed control closet to the outlet (lowest in the chain) is responsible for In what sense does this make sense? In the case of a fan, if it is set to Medium, all subsequent fans will be set to Medium as well. It was necessary for me to set my first fan to High, then my subsequent fan to Medium for my needs in order to get the necessary airflow. This is a minor issue, and of course since the devices are USB-connected, you can always get USB outlet adapters to get around this. A star deduction was not necessary, as I had a small inkling that this might happen.

Joshua Palmer

| Apr 02, 2021

One negative comment I have is that the speed switch runs pretty hot, which might have an impact on the fan's life. In the next few days, I will follow up Any problems with the fans should be brought to your attention. This is one of the best purchases of the year as of yet. Hopefully this article was helpful to you. Give me a thumbs up if it was.

Kenzo Blankenship

| Nov 16, 2020

The fans I have purchased were a great purchase for me. They serve an uncanny purpose for me. They are They are attached to a mining rig submerged in mineral oil for cooling, which is an Antminer S9. While the fans spin slowly in the oil, there is enough circulation to move the cooled oil by the hot This has been running without a hitch for over a month now. Please take note In fact, I accidentally unplugged these fans, causing the operating temperature of the mining rigs to spike. The fans are so essential to my design that this proves it. In terms of their intended purpose of cooling gaming boxes, they are well built with thick rubber feet to both hold them down and keep them quiet at the same time. It spins very well in the air and is very silent.

Astrid Ewing

| Sep 23, 2020

Let me say two things right off the bat AV equipment is not mounted as intended and is not being used. However, please take a moment to read the It is awesome to have this AC Infinity blower and these fans, both are very quiet, but not unheard because they are not silent. Excellent for a quiet room, but very quiet nonetheless. In the past, I built custom cooling for my older AV cabinets and computers, and in need of a cooling solution for my home network gear but wanting to avoid the 80mm PC fan screens and 120mm PC fan whispers, I stumbled across this brand and some solutions others had used. PWM (DC power equivalent of VFD for AC) was attractive to me because I was looking for a high, yet controllable flow, and this brand delivered exactly what I desired The three conditions are flow, control (O/L/M/H or an optional controller), and Despite my disappointment, I have not been The source of my research was a well known brand and their components and systems for nearly a year and I have not been able to locate a reasonable product in terms of performance and price Even though they were not a perfect fit for my needs, I was able to devise secure, reliable and effective mounting solutions for each of them. Please take note Since the twin fans are factory wired to the same harness, they are limited in their distance placement. Installs that are designed to be used as per their purpose will not be an issue, but custom installations are a consideration. It is mounted on equipment that is just under 12" in diameter. It is centered We have enough slack in our harness to keep us at the center. A - *br*br* A summary of how many days have passed since the start of use A) Gremlins in both my wireless and wired Thank you for your help. I am very satisfied and going to kick myself for not getting this I was already planning to install the controller and am going to be purchasing more ACI cooling equipment soon so as to give my AV equipment the same treatment. I like it a lot.

Kellan Huffman

| Sep 26, 2020