400W Adjustable Treble/Bass Frequency Divider Distributor 2-Way Speaker Audio Crossover Filters
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Eight-word sentences with pictures You get two-ohm drivers if you use drivers a, c, d A 4-way crossover at 4200 Hz may still happen if you use all jumpers, but the woofer becomes a Bandpass at 150 Hz on the low end and 4200 Hz on the high end with the tweeter starting at that frequency.
Low bass frequency is what it is used for. As far as I know, there's no setting for it. My Kennewod receiver runs from a subwofer to the kenned receiver.
In the diagram above, you can see the woofer on the right side of the two output connectors
Based on a spec sheet for the crossover, I believe it can be used with speakers from 4 to 16 ohms. 8 ohms is what I think it is, though I am not sure. There appear to be three sets of screws connected to the terminals. There's one side of your single set that's for the input, and one side is for your tweeters and woofers. The video also includes a description of the jumpers, but the default sound was best for me. This is an English article written in poor English that is difficult to understand. The following items fit into the following sizes 1)Size 7x5*2. 2)Applicable for speakers up to 5 cm high (LWH) 3) Suitable for speaker impedance 400W or lower There are 4 jumpers onboard to help you tune up your audio Jumper A, B for bass Jumper C for midtones Jumper D for treble Jumper E for treble C and D are the jumpers for the
Selected User Reviews For 400W Adjustable Treble/Bass Frequency Divider Distributor 2-Way Speaker Audio Crossover Filters
Rather than a high-end device, I made this low-end Filter by passing it through a full-depth filter This test was done with a mid-range speaker. Despite a limited range, you could still hear most of the highs and mids. The filtered speaker was placed right next to a speaker without the filter, so I could use the balance control to swap between the two. The filtered speaker sounded slightly quieter and muddy on the mids and highs, but it nearly did not filter them out. It was explained in the product description that I had to try various jumper configurations. The jumper configurations did not appear to make any difference to me. I am disappointed.
Restoration of a 1964 Magnavox console stereo is currently in progress. I decided to swap out the crossover since it was broken. The two that I bought are in my possession. Each channel requires a separate code. Once I installed both crossovers and wired them all up, I was astounded. This crossover produced an incredible amount of sound quality at such a low cost. I have been using it for a little more than a month and I haven't experienced any distortion or issues. I'm very happy with it thanks to its 8ohm woofers and 16ohm horn tweeters. It would be great if they made a 3 It is a crossover of two ways. Then I will make a new console based on that.
This sound is horribly loud. A refund was requested for an item that was returned It has been months since I received a.
In order to do an internal rewire job on a few Marshall Stanmores that were dead, I purchased a pair of these. Installation is quick and simple. The device is easy to adjust. It performs its functions as it should. This is a highly recommended book.
These were used to re-create The purpose 4 of the project I used to have an old Panasonic stereo system with wire speakers. It's hard to believe how good they sound for their price.
A slight change has been made to the design There has been a complete change in jumper configuration. These have been removed and are replaced by two pin headers, four pins for the first and five for the second they're entirely inscribed in Chinese, as well. You will not find any instructions The only way to figure it out is to find a friend who understands Mandarin.
I love this.