Hobart 202926 0.030-0.035 and 0.045 Drive Roll VK Groove for Select Handler and Ironman Series Welders
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This would be a good A Miller Multimatic 200 is equipped with the part number 261157 drive roll
A handler 180 will work with this drive roll
It is the 210 handler only with a 220v power supply. It is essential that the mvp is also active
Selected User Reviews For Hobart 202926 0.030-0.035 and 0.045 Drive Roll VK Groove for Select Handler and Ironman Series Welders
I bought it to solve my wire feed problem on my Mig welder. I bought this wheel when I bought a new feed line using my old feed line it feed my wire on demand every time there was no skipping, stopping, and it ran perfectly, I would never buy another smooth wheel again! There is no doubt this wheel is my favorite! ALPHA RAN BETTER THAN EVER! This is the only wire I use, so it's a must for flux cores. There's no other way to put it than BUY IT! This will be a good decision you'll never regret.
Bought it for my Miller/Hobart. Flux was not working for me - Slipping cored wires & slipping anchor bolts The feed is not being fed In this case, the correct solution is to solve the problem. To ensure your welder lasts as long as possible, do not just tighten up the wire pressure adjustment roller. This may cause more wear and tear on your machine. In this new generation of A cored drive roll has a knurled edge on the side of the wire groove that bites into the wire and prevents slippage. Great for running shielded flux it is a must-have if you have any plans on doing so This wire looks like "cored wire" through a Miller or Hobart drive rolls. It is easy to install and swap the drives. The roller lever for release of wire pressure is located on the bottom of the roller. To remove the drive roll, push and rotate it, and then pull it away. Afterwards, all you have to do is roll on the flux core roller. In my welder, I keep the ends of the drive rolls I am not using beneath the wire spool to keep them from getting The Miller product is of high quality.
This new factory part is designed for easy replacement. In all honesty, if you can't easily install and adjust it you probably shouldn't be operating.
It is very nice that the channels have grooves that firmly hold the wire, I installed it on my MillerMatic 211 and it works great! This is a quality product that I highly recommend.
You will need this cable if you have a flux core wire machine. It keeps the wire from slipping and you would end up burning the feed motor if you simply increased the tension. The 20 bucks are well spent and you will have fewer headaches. Miller/Hobart ought to package this with the welder, so it receives my 4 stars.
A better feed grip on wire is provided by this roller, as it forces the liner through the wire while the mig wire kinks and wraps around the feed bearing on the.
The flux core welding technique has been significantly improved. My life has been changed by it.
The item I was searching for was just what I needed, priced well, and arrived quickly.