EEZTire-TPMS System Booster/Repeater
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I would recommend that the best place for the computer would be in a back closet high in the motorhome. Using this with a DP, it accurately reads the Toad that has been parked 50' away for the past three
There's a 433 in this file. There is a 92mhz working channel, but it has to be used with our TPMS Some TPMs are not compatible with each other
There is no switch to turn it on or off. It will only come on if the ignition switch is in the on position if you wire it to a switched power source. I'm not sure if it's waterproof or not. Located in a cabinet mounted on the back wall of my conversion, it is used to play music. I love how it works! Using my tag tires no longer causes me to lose signal.
It is stated on the Eez TPMS website that the main system (monitor, etc.) is warrantied for 3 years. That should also apply to the repeater.
Selected User Reviews For EEZTire-TPMS System Booster/Repeater
The fifth wheel I have is 42' long. I am using this with a Zeepin TPMS 1 which I bought on I believe you can use any 433 as long as it is 433 or higher. These relays are suitable for TPMS systems that operate at 92 MHz. It is easy to install and comes with a built-in temperature sensor and a fuse protection setting. Connecting the positive and negative connections is all that is required for installation. There is a lot of thin wire A red light comes on once you have done it, and that's all there is to The one I have is mounted on the inside of the front wall of the storage compartment right after the pin box on the front of the 5th wheel. Around it, especially where you screw it down, you'll want the least amount of metal. As soon as my truck was hitched up to my trailer, I immediately saw the TPMS transmitters from all 4 trailer tires from the Zeepin TPMS receiver on my dashboard. The temperature and PSI also updated as the system updated itself after the initial installation. There are limitations to how the Zeepin TPMS relay operates, but that has more to do with the Zeepin device itself. Although the TPMS relay works normally at a long distance (30+ ft), it is obviously not designed for an extended distance. Although I haven't taken it on the road yet, I expect it to work just as well as anticipated. TPMS relays are unlikely to cause any issues, because any problems are likely to pertain to the TPMS units themselves. As soon as I uncover any issues with the relay, I will update my review.
It's amazing how much difference there is. No place was available in my motorhome where I could place the receiver and be able to get signals from the 4 tires of the towed car and the 4 tires of the motorhome. I found it to be quite In order to purchase this Booster, I ordered it. As I had imagined, it was much smaller than I had expected when it arrived. A short cable (3 feet or so) with tinned leads requires 12 volts of electricity. The cigarette plug was purchased at the same time, and I used the leads to connect the plug to the 12v socket near the rear of the My booster appeared to work once I plugged it into 12v and it turned on its little red light. A general area around the rear wheels of the motorhome served as the place for me to lay it out on the floor. After that, I placed the receiver/display on the front dash of the motorhome (over the front wheels) so it was easily accessible. Honestly, I was blown away by this! From ALL tires, I was getting good reports All 4 wheels on the towed vehicle, as well as the rear wheels of the RV. There was a significant improvement over the previous version. It has been about a week now since I used this over a 1,000 mile trip, and I'm sure you can tell it has been a great improvement. will not be able to get rid of it, so I will have to figure out how to wire it into the motorhome's electrical system permanently.
When my RV was on a trip, the signal from the EEZ RV TPMS system would come and go, and the sensors would come and go as well. I was able to resolve the issue by adding this booster. I mounted it inside the RV on the ceiling next to the forward light fixture and plugged the power into it. I can stand 100 feet from the camper and it still reads the sensor very well. My trip gets off to a great start when I turn it on before I leave.
Does what it's supposed to. There is a switch on the front of the unit that doesn't seem to do anything. This unit would have been five stars but for that. On the front is a light that seems to be controlled by a switch, but does not seem to work. There would be no problem if a switch was built-in. Rather than wire directly, I had to connect inline, which was not a big If you get the EEZTire TPMS system as well, I recommend that you buy this booster as well. Previously, I experienced intermittent readings from my sensors every couple of miles. After installing this booster, I get a consistent reading from all sensors within 800 miles. In my 30 foot fifth wheel, this booster is installed in the outside storage compartment in the front.
I am very satisfied with this product. cannot receive signals from the tire pressure sensors intermittently when I use the EEZ Tire TPMS system. A worker would stop working after about 20 to 30 minutes, and then the others would join in. The sensor ceased working on a different occasion every time. As soon as I added the booster, the issue went away. I took a 6700 mile trip in the last couple of months, and the sensor signal did not deteriorate A booster was attached to the front wall of a compartment for storing my fifth wheel in the basement. It was necessary for me to use extra cable in order to connect the booster to power. The booster was also hooked up to a switch so it would not always be "on", draining the battery in the trailer. This product has been very helpful to me.
My rig is 36ft long and the rear tires have always took so long to display to my surprise. . . . and now BAMM! I connected this to one of my pockets and now I'm all set! I was able to display my links on the fly. In the case of install, I gave it four stars since I had to run a circuit for key power so that my batteries would not be constantly being consumed. This would be a much more useful device if the designer had incorporated an automatic on/off circuitry.
In my 40ft diesel pusher, the 12v power supply was mounted just ahead of the engine in the basement compartment where I had easy access to it. The problem of signal loss after traveling for 15 to 30 minutes was corrected. Though it would probably have been easier if I had read the instructions more carefully, it works just fine where it is. I only wish I had read the instructions more carefully since they mentioned mounting it inside a closet or cabinet right near the rear of the RV.
This is an excellent product but I was not able to get it to work. When contacted by customer service, it was discovered that this unit had been set up by the factory for use with another one. To turn your computer on again, turn it off again, and press the center button 10 It works with other sensors they sell when this setting is changed. As a result, it worked for me. There are no directions with the.