B&M 46076 Launch Control Solenoid with Installation Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
An inlet and outlet are located in a single location. Apparently, there were 1/8 pipe connectors in the package. I remember it came with a few fittings to connect to the pipe. When your ABS divides the system, it can be difficult to set it up for rear wheel burn out control if you have such a system.
The truth is, it is a universal solution that would have to be made to
It is only locked when there is 12 volt power available.
The front or rear of the machine can be worked on. A diagram that is easy to follow with instructions
Selected User Reviews For B&M 46076 Launch Control Solenoid with Installation Kit
A. & C. Having M Launch control is a great way to lock in on a line. The switch is included in the set so that it is ready for connection. As it is designed, it works perfectly as it should and I was able to get good traction or staging when I did burnouts. Unlike a certain generic brand where the threads had burrs in them, the threads of these are well-cut. I received it in a package from B &amp Q The products are packaged in an Amazon box as well. Because Amazon did not place bubble wrap in the box, it was unable to fit within the box, but that's their problem. The instructions are clear as they show all possible installation options, I was able to install the unit in about an hour. In the case of a less experienced person, it may take them 2 to 3 hours to do it properly. B & D A hill holder is what M advertises as this product. It is not intended for use in that way, although it would work if you are unable to take off from hills in a manual, so I would ignore the bad review saying it does not A parking brake does not exist here! This hill holder is labeled as a hill holder so it can be sold and installed in some states that view it as only suitable for racing purposes.
It did not come with the connectors to attach to the brake lines I will have to determine that myself. Most kits will have connectors in them, so you'll get the best value out there.
It should have an inverted flare inlet and outlet. Very cheap electrical switch. Fittings must be adapted at a very high cost.
I'd definitely buy again if I needed to.
Despite doing everything I can think of to get it to work, I have yet to succeed in getting this to work. There is no way to hold pressure on it.
You can either wait at the line until you are ready to launch, or you can run on a hill if you get stuck on a grade. According to the product description, it holds you on a hill until you are ready to launch. As a result of reading the label on the box, it stated "hold for maximum one minute. ". My choice would have been zero if the numeric value were zero! It's a big disappointment.
The product met the expectations.
Thank you, everything went well.