Gas Engine Switch, Rcexl K1 V2.0 Fiber Opto Gas Engine Kill Switch for DLA DLE DA Ignition Cut Off
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For Gas Engine Switch, Rcexl K1 V2.0 Fiber Opto Gas Engine Kill Switch for DLA DLE DA Ignition Cut Off
On a gas engine I noticed that I was losing big signals, and I also saw it cutting on and off while I was running. Previously, I had this fitted to a gas RC engine in an Intruder plane. After removing it from the system, everything worked as it should. You need to be careful because the second one also did the same. When checking your Telemetry, if you observe any holds or signal loss, I suggest removing the cable to see if that stops the issue. Flickering of the signal light is just as bad.
If the money can be refunded, I would appreciate it. Despite uninstalling, my rc will not turn on at all, not even after I try to remedy the problem. I don't even know what that thing fried yet. When I turned on the kill switch, it smoked a little and then I had no power. I charged the battery but it did not work. The HPI Baja was the platform for the installation. I have a fried on/off switch, due to an electrical fault.
To replace another switch that I thought was interfering with my receiver, I bought this. I have not noticed any interference since I installed it. It's easy to set up and install.
My 2 cycle engine received a wrong one, but it seems to work very well for nitro engines. I had ordered the wrong part for my nitro.
Flying a rc.