Pro Comp 62698 2.5" - 3.5" Radius Arm Bracket for Ford F-250 and F-350 4WD
Score By Feature
OveReview Final Score
Questions & Answers
On top of the springs, I had a spacer from a leveling kit. I needed to correct the geometry, so I bought this kit and followed your instructions to the letter. I didn't use the one-inch spacer that came with the kit.
2005- The radius arm setup on 2019 f series trucks with 4wd is the same, so these should fit any of those years.
It includes drop brackets and 1" spring spacers for the coil spring's bottom. So, if you install the blocks, you'll gain an extra inch of lift. I have 2. On top of the coil, place 5 spring spacers, then this kit for a 3. 5” kit.
Selected User Reviews For Pro Comp 62698 2.5" - 3.5" Radius Arm Bracket for Ford F-250 and F-350 4WD
"2. ", I reasoned. The "5" in the title meant that this kit could be used on anything that was lifted between 2 and 5 pounds. 5 to 3. 5 inches. In reality, it's designed to take your already-lifted truck and make it two inches taller. 5" and raises it another inch to 3. 5”. br>br>The drop brackets restored the factory caster angle, allowing my truck to drive like new on the highway. My truck looked great after being lifted, but it was a bit shaky on the highway. With these brackets, everything is fine now. br>br>It's also a fairly simple process to set up. Get some sway bar end link extensions as well, if you haven't already. At 3. Because the sway bar is only 5" wide, certain corners and bumps can cause unexpected handling.
Amazon delivered the parts in a timely manner. The radius arm drop brackets come with all necessary parts and hardware, as well as two 2" aluminum blocks to place beneath the axle's lower spring retainers. Only on a 2013 F350 6 did I use the radius arm drop brackets. 7 diesel. I didn't have to use the aluminum blocks because of the leveling springs I used. Torquing the radius arm bolts to 222 ftlbs and 230 ftlbs will be the most difficult part. A 3 ton jack, 6 ton jack stands, and 24mm nuts and bolts are required. A 27mm socket or impact socket, a large 18" long 1/2" or 3/4" drive ratchet, an impact gun, and a torque wrench capable of 250 ftlbs of torque are all required. The instructions are straightforward and simple to follow.
Great product with easy to follow instructions and setup.