Spark Plug Protect Boot 1800 Degree Heat Shield Thermal Protection Insulator Sleeve Spark Plug Wire Boots 6 inch for Car Truck (Pack of 8)(Titanium) (Red)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
You will find a metal split ring inside the bolt. Insert a tool (I used long handled needle nose pliers) and you will be able to The boot can be closed by squeezing the ring after it has been placed on. Here is a translation I hope
Since I put them on my 454 Chevrolet with headers when I was having problems with burning plug boot's, I have not had a problem with them since.
can fit up to two people The diameter of the spark plug is 5 cm
A month after I bought them, they were red, but anything that touched the header burnt the color out, and are burnt white today. It is still their job to do it.
Selected User Reviews For Spark Plug Protect Boot 1800 Degree Heat Shield Thermal Protection Insulator Sleeve Spark Plug Wire Boots 6 inch for Car Truck (Pack of 8)(Titanium) (Red)
It is made from 5mm superconducting wire. Modify MSD 8 to fit your needs. I don't have a problem with 5mm Superconductor LS1 wires. modifications have been made to the metal ring or the sleeve.
It's a low quality product. I have also heard others say that they do not fit over the wires (10mm), but you can open up the ring (it's split) sewn into the material and then fit it in without having to cut It is evident that aesthetics is a major problem. Although you can get the colors over the boots, the color(my "were" red) has now been completely wiped off the product and is now Some of the ones I was able to observe in a semi-meaningful way A run of maybe once a day for 1 week in the salvage had the color gone. This is not a good purchase. These have been thrown away as I am searching for a quality set. As if they were a joke on real engines or even from a junk yard.
In my case, the spark plug wires could not fit through. As a result, I could not use it. The stock wires on my LS truck are too old for me to take apart. Decided headers would be helpful, so I put them on. The answer is no. In the material, there is a ring.
I would constantly be burning wires if I did not have these boots. It's not a problem to install these boots.
During the summer of 2001, I installed them in my The boots on the plug wires made it extremely difficult to get them off. They were so tight I had to pull on them so much that my hands were stained with red dye. As a result, the boots looked “old” and worn. As this is the only set I've ever attempted to install, I'm wondering if they're all such a pain.
There are more than ten pieces in the product. Spark plug wires are 5 mm in diameter. While they tend to smoke a bit until the color is out, they seem to be fine afterward.
While these were not my own creations, I am nevertheless pleased by the outcome. This is a L67 6 that has these installed. The Pontiac G8 GT is a zero horsepower car.
Here is a video and picture guide that will help you. Quality is decent, but they're too small to connect to OEM In order to finish, I had to disassemble them in order to get them over the wires. I am sure it is possible, but it is a.