MOTOALL Ignition Coil Connector Plug Wire Harness Pigtail Wiring Loom 2-Way for Ford 4.6L 5.4L 6.8L 1991-2011 & Lincoln Mazda Suzuki - 8pcs
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
A wiring harness that connects to the ignition coil is shown here.
Only Ford vehicles can be fitted with these
The 2003 Mazda Tribute is compatible with this item.
No, the plug is just covered in rubber seals on the back to protect the wires and is not protected by As I did not use these for auto repair but for another project, I can't be sure what the point is for them to be angled in that manner.
Selected User Reviews For MOTOALL Ignition Coil Connector Plug Wire Harness Pigtail Wiring Loom 2-Way for Ford 4.6L 5.4L 6.8L 1991-2011 & Lincoln Mazda Suzuki - 8pcs
However, the connectors themselves are compatible. Fuel 4 is the same as fuel 3. 6) and snap into place just fine. But, if you're hoping to remove the pins from the OEM connector as well as these replacement connectors and do just This is due to the fact that the replacement connectors' overall design is different from the OEM's connectors, which means that the OEM pins can't be plugged As luck would have it, Ford doesn't offer replacement OEM ignition coil connectors as far as I know, so you can either get them on Amazon and do some wire splicing yourself, or find some OEM connectors from an (preferably) low-mileage 4 and install them there. The engines for these vehicles are typically 6L Ford/Lincoln/Mercury V8s from a local junk yard, and once you try to remove the pins from them they are likely to crack apart due to prolonged heat exposure, so low mileage vehicles make good choices. Hopefully, this review will save somebody some time and/or frustration if they choose to DIY.
During the summer of 1962, the ignition wire cable harnesses on the spark plug boot were cracked and brittle, and could not hold the spark plug harness in place. With a thumbtack, I removed these pigtail leads from these new harnesses, then removed the existing cable with the pin attached from the existing wiring harness plug, then attached the existing plug to the new harness. The splicing did not need to be done! It is hard to find a better.
Recenty, when replacing the intake manifold, I had a couple of the original connector retainer tabs break during the process of removing and reconnecting. I found these replacement connectors to be the perfect answer for my easy and affordable replacement needs!.
This is the best deal - you can't find one at a part store for less than $20 and it fits my 2004 Expedition The following 4
(Will fit the A total of 4 engines).
It worked great! The factory pins in the connectors would not fit the holes in the connectors, so I had to splice when I anticipated that the plastic connectors would be able to be used with the factory pins.
The ignition module connection plug can be replaced with an electronic version if the original one is old or has damaged My sincere thanks.
Wire leads are long enough that there will be some extra length. It is easy to splice them together. This gauge looks identical to the original, and you can plug it in and unplug it I would definitely recommend this.
Although they are not easy to install, they work perfectly once they are. Item of very high quality.