Knock Sensor Harness Intake Manifold Gasket Kit,12601822 104566030 Compatible with Chevy,Pontiac,Buick,Cadillac,GMC,89060413 MS92211 MS18007 MS4657 MS16340 by Lucky Seven

I was able to order the complete kit at a reasonable price. Afterward, I received an error PO0327. After removing the intake manifold and replacing the sensors, I replaced the fuel pump. If you are going to install additional sensors, make sure that they are properly cleaned (A MUST. Ensure the area around sensors is clean and free of dust. So that the threads wouldn't corrode again, I used anti-sieze for stainless steel on the threads. Once the sensors have been installed, they will be properly torqued. Reassemble the engine and make sure that the sensors are grounded to the engine block. The threads need to be removed and re cleaned if they aren't already. Those of mine were torqued to 80 lb. Please note The weight of your feet should not be measured in foot pounds. We joined the harness and applied silicone grease (NOT silicone sealant) around the outside of the rubber boots to prevent water from seeingp in. After installing the new gaskets and reinstalling the intake manifold and other parts, the vehicle powered on. With the help of the scan tool, corrected the error code. In the second step, I revved the engine for 3 seconds at 5000 RPM four times in a row to re-learn the sensors. In the event that the sensors are not relearned, the ECM will think there is an error and throw the error I no longer have any codes and my engine runs better than it did before. My suspicion is that the sensor(s) failed for some time, so the ECM programmed the ignition timing backwards as a result of losing A great kit, I must say!.

Omar HEWITT

| Mar 22, 2021

The durability of the shoes will be determined by how well they stand up, but everything that was needed was included. With a 6, 2002 was a good year. In my opinion, it was missing intake gaskets because it wasn't doing well, popped, and did not have When they are too lean, these trucks behave that way. The leak of large amounts of vacuum.

Chelsea Nguyen

| Dec 17, 2020

I've had no engine check light since setting it up on my 04 Sierra GMC.

Lexie Thornton

| Apr 12, 2021

I replaced both knock sensors in this kit and the wiring harness as well, but I still get the same error.

Diana Marshall

| Mar 20, 2021

They say that go cheap, get cheap the original (green GM) doesn't bend the (red) is cheap plastic that bends badly and feels like it will snap off at any moment.

Aniyah Maddox

| May 30, 2021

There are no problems with the intake gaskets.

Malaya Davis

| Jun 17, 2021

On Thursday as soon as I put in my 04 Chevy Silverado, I drove the truck around a couple of days and I found out that one of the knock sensors was broken so I had to have them changed all over again on Friday.

Charlie Pruitt

| Aug 13, 2020