Speedi-Sleeve And Tool Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Do you have a leak in the shaft of your water pump? If you want to sleeve it, that's fine. It is sometimes difficult to find the sweat spot I've had to use two shafts side by side in the past due to the wear on my shafts. Be sure to use red ultra thread lock on the sleeve to keep it firmly attached to the You should grease the seal lip with marine water resistant
do not just go by the year or make of the boat, you use a mic to get the right size of the large part of the spindle where the seal runs
This is what SKF does A nominal shaft size of 1 is listed on the CR. A Min. of 719" The maximum number of characters is 715. This is "721". We appreciate your interest in the project. It is owned by Atmus Corp.
It is correct
Selected User Reviews For Speedi-Sleeve And Tool Kit
Use a generous amount of Evinrudes gasket sealing compound to brush on the shaft before driving the seal on. As well as driving the lip up far enough, make sure that the facet clears both the score and the Neither the drive up flange nor the plate is needed to be removed. The sealant is held in place by this. Seal ix is similar to bearing buddy's seals, but you can now not use the old seals.
It's perfect for repairing corroded boat trailer seal surfaces when you're doing routine bearing inspection on your spindle. You'll have peace of mind knowing that premature bearing failures will not occur in the future.
Product of excellent quality.