SHOEI HS-CWR1 PINLOCK CLEAR EVO INSERT for CWR-1/CW-1/CNS-1/CNS-3 SHOEI SHIELDS
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Without a doubt. There are no clouds during daylight hours. When the daylight has gone, it is pitch black.
Selected User Reviews For SHOEI HS-CWR1 PINLOCK CLEAR EVO INSERT for CWR-1/CW-1/CNS-1/CNS-3 SHOEI SHIELDS
Since I have used Pinlock systems on almost all my helmets for more than 10 years, I have no plans to change. I am fully satisfied with the performance of the system once it is installed and adjusted. It would constantly be a struggle to keep my face dry when riding in torrential downpours without the Pinlock system You can defog it by using a shield. Fogging of the face shield is no longer an issue thanks to the Pinlock system. Tip The following are a few suggestions 1 .
By attaching the insert to the face of a sealed double-paned window, this solution creates a double-paned window with a two-tone appearance. This shield protects. If you choose to install an insert, follow the installation instructions and make sure the arrows (pointer) on the post face forward (since the shield sits closed on the head) otherwise, the insert will not fit. In the event that you encounter any fogging under the installed insert, rotate the Pinlock mounting posts a little bit on each side (repeat this procedure until the fog disappears). As well, make sure you align the post pointers with respect to the helmet when you make adjustments It helps to rotate each post 45 degrees up and forward, straight up, straight down, etc. It ensures that the cam surfaces of the posts are oriented the same and forces an equal forward advance on .
. Because the insert is hygroscopic (absorbs moisture), any moisture that accumulates between the shield and insert is immediately absorbed by the insert and absorbed by the shield. Therefore, it is recommended to never clean the insert with water or let it It is unlikely that this will ruin the insert, but it will shorten its life. I have occasionally found that rain drops have dripped past an unsealed face, causing my books to get damp. It has been quite some time since they last failed, but they all keep working fine.
I'm replacing the Shoei Neotec 2 helmet for the first time since buying it. In the event that it is not cleaned properly, the material is very soft and easily scratched.
SO, the first ones, which were already inside of the helmet, got scratched and needed to be replaced next. Cleaning that isn't done correctly. You ought not to assume you are capable of cleaning Unlike any ordinary shield, this is not ordinary. As long as you have the right materials and cloth to get the job done, when you install and leave it on, don't bother cleaning it unless you have a proper cleaning agent. It is far too costly to be replacing all of the ozone every time.
On my Shoei GT-R, I have this installed I have experimented with a Pin Lock fitted to an AIR II helmet and found that it fits just right without any room for installation It can be too low for the face shield not to close, and too high for the rubber seal of the Pin Lock to be scratched. Now that the scratched pieces are exposed to the sun, they become distracting and can damage my vision.
This is a false statement. In a nutshell Since it is listed as compatible with shoei x fourteen in the description, it must be a lie. There is a lack of that information.
Since I installed this, my helmet has not been foggy.
There is nothing negative to say.
There are a few challenges involved with installing these It is very important that you take care Don't touch it - it is a delicate thing You will need to install it once it has been installed. There's no need to worry.