Evan-Fischer Tail Light Assembly Compatible with 2007-2013 Chevrolet Silverado 1500 Driver Side
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It includes the light bulbs as well as the wiring harness. If you don't want to fiddle with the wiring harness, just replace the housing.
The body of a six-cylinder engine and an eight-cylinder engine will be identical. This will work with the body of your 2013 1500.
In my (2012 Silverado LT), the current bulbs and harness worked fine, making it a simple swap after it was broken in a parking lot.
I don't think so, but I do have a new style for 2007.
Selected User Reviews For Evan-Fischer Tail Light Assembly Compatible with 2007-2013 Chevrolet Silverado 1500 Driver Side
It appears to be identical to the original. Installing was simple, but if you're not sure how to do it, watch a YouTube video. The video for A1 Auto is excellent. Remove two screws, pull out the old unit, remove the tail light bulbs, disconnect the harness from the junction, and pop out the old retainers. Then run new wiring through the hole, install the tail light, route and connect the harness to the junction, and secure it with two screws. Done! Before plugging in the new wiring harness, I applied dielectric grease to the contacts, as I always do on auto wiring that is exposed to the elements, but this is an optional step. The only "complaint" was that the old harness had two retainer clips that held the harness in place, but because this unit's harness is a little larger in diameter, those clips couldn't be reused. The two clips could have been included, but they aren't required. br>I'd buy it again without hesitation.
After a few weeks of rain in Washington, the reverse began to fog up. It was fine for a few rainstorms, but it is now constantly flooded. There's no need to be concerned because of the Vleds. However, it is not the most expensive, so you get what you pay for. I replaced both of them, so the other is fine.
Perfect fit and significantly less expensive than OEM, but when installed as shown in the video, the plastic tabs that hold the pins that go into the fender broke off almost immediately. I removed the grommet from the pin on the next one I bought, installed it in the fender, and it fit perfectly.
I rarely give four stars, but this one deserves it. It arrived quickly to replace a busted tail light and was very reasonably priced if you compare it to what you'd pay at a dealership. It was simple to install and came with a light harness, which I wasn't expecting.
I was pleasantly surprised by the speed with which it arrived and the quality of the packaging! Given that the original was much more expensive from a dealer, the price was fantastic. The only issue I had was removing the rusted original screws that held it in place when I installed it! IT LOOKS AMAZING! I only spent 20 minutes replacing it, and I've never done anything like this before on any of my trucks. I'm hoping the person who drilled a hole in my original taillight doesn't do the same to this one!.
This was a fantastic unit that arrived in the mail, complete with all of the lights turned on. everything was pre-installed and ready to go My only minor issue is that I don't have the necessary software installed. I wish they hadn't used the clips that were inserted into the body because they were a pain to remove. Apart from that, everything is perfect.
As the headline suggests, it's a perfect fit. I was also surprised that it arrived much sooner than expected. It only took me ten minutes to remove the old one and replace it. My vehicle is a 2007 Chevrolet WT-.
Installing it was a breeze. It only took three minutes to complete. It was simple because I used an existing harness. If you use the harness provided instead, it will take a little longer.