Amazicha 1157 2" Bullet LED Front Turn Signals Light White Amber Blinker Light Compatible for Harley Davidson Sportster Softail Touring Dyna

$ 15.90

Score By Feature

Based on 345 ratings

Brightness

9.29

Value for money

8.72

Easy to install

7.56

OveReview Final Score

How Our Score Is Calculated

Product Description

By entering your model number, you can make sure that this fits.

It is LED Turn Signals Compatible for all Harley Davidson models, including Dyna, Street Glide, Fat Boy, Softail, Road King, Springer, and other models with 2 inch standard bullet style front turn signal lights and 1157 double contacts bulbs only, not for rear turn signal, and not for aftermarket replacement housing.

NOTE: The turn signals on Harley Softails 2010 and older, Dynas 2011 and older, Sportster 2013 and older, Touring and Tri-Glide 2013 and older models may flash faster than usual. The load resistor is essential if you want a slower flash rate. Our turn signals are built to last longer than your motorcycle!

The latest trends in fashion

Easy to Install: Most models have plug-and-play replacement turn signals that don't require any wiring. Load resistors are required on Harley Davidson models from 2013 and earlier. 3-1/4" Flat Style turn signals are not compatible with this product. The two screws that hold the lens to the base distinguish flat style turn signals.

2 LED light panels are included in the package; however, there is no instruction manual.

Questions & Answers

Will these wheels work on a '20 Road Glide Limited?

I have a special for the 2020 Road Glide. The lights are the same. They appear to be fantastic.

Snapping the lens into place is not an option. The lens is too small to allow light in. I'm not getting it. ?

I have the stock turn signals, which sit inside of where the lens goes in, so there isn't a problem with the lens snapping in. Before you put the lens on, double-check that the lights are turned on all the way. Check to see how much space is left after the lights have been turned on inside the turn signals. Lights are unable to pass through the lens because the clips are unable to flex sufficiently to lock. If not, perhaps Harley-Davidson or someone else could change the size of the turn signals on the bike, as some riders have turn signals that aren't stock. Best of luck to you.

Are these compatible with a 2014 Ultra Glide?

It will fit as long as the size is 2".

I purchased a set and am very pleased with it. My question is this: the blinkers work normally, but they appear to blink twice as fast on the dash; is this a problem?

Turn on your flashers for 30 seconds before turning them off with the ignition.

Selected User Reviews For Amazicha 1157 2" Bullet LED Front Turn Signals Light White Amber Blinker Light Compatible for Harley Davidson Sportster Softail Touring Dyna

They're super bright, but they're a pain to put together! This is a powerful, bright, and pure light source! They add at least 30% more visibility and brightness than my led headlight alone at night! What a distinction

4/5

br> br>I'm so glad I picked these up! br>br>I had these installed on an older Harley Electra that I had converted to a street glide. 2018 Street Glide front turn signal housings and lenses are currently available. br>Like others have complained about, getting the base of the led light into the housing is a real pain. It took some tinkering to get them to fit beneath the stock lenses. It’s 100% worth the hassle and effort for the added brightness and safety they give you
It’s 100% worth the hassle and effort they give you for the a br>I didn't have to make any changes to the stock housings, but I did have to get creative with how I pushed the base down and twisted it into the light socket. They were turned with a pick and pushed down with a screwdriver. The edges are razor-sharp, and they fit into the light sockets perfectly. This is something I can't do with just my fingers. br>It's time to give this a facelift! br>So far, they've been flawless, and the drl features, as well as the momentary Amber turn lights, are unquestionably the best features of these! br>br>I fixed my stock wiring, which wasn't set up for drls in the turn signals. It now works like a newer bike, and I saved tens of thousands of dollars by using these instead of buying a new streetglide! br>br>Overall, this is a fantastic product that is well worth the money and the hassle of installation.

Pedro Little

| Jan 20, 2021

Take your time and be cautious

4/5

The product must be inserted into the stock bulb plug in a specific way with your fingers, or they will not light up, or only the white or yellow leds will light up. I initially mistook them for defective, but after removing them and rotating them 180 degrees, the top pin became the bottom pin, they functioned properly. Once they're up and running, they're fantastic. They're delicate, so take extra care when putting them in. The plug is flush with the surface where it is inserted. It would be easier to insert them and then turn them to lock them in place if they protruded a little more.

Mira Moyer

| Oct 27, 2021

I placed two orders and received two completely different items

3/5

Due to a project I'm working on, I purchased twice and received two completely different items. I first ordered it and then reordered it two weeks later. The second set I received had thicker LEDs, thicker wiring, more surge protection, and were noticeably brighter. If anyone else buys them, I'm hoping they get the same ones I did the second time around.

Belen Glover

| May 04, 2021

It has an excessively large outside diameter

3/5

I put the bulb socket end of this item into one of my 2003 Harley Davidson Vrods front directional light housings and it worked perfectly after 7 days. After 8 attempts at the cover not snapping in properly, leaving an air/water gap, I removed the disc from the housing and tried to fit it between the tangs on the orange lenses cover, but it would not fit between all of them/so no go. I'm returning the items because the diameter is a smidgeon too large.

Gwen Donnelly

| Oct 05, 2021

So far, everything has gone well! These were just delivered and installed today

4/5

The left signal did not work at first, but it began to work after I repositioned it in the housing. The running lights are particularly bright, which I find appealing. I installed front and rear LEDs, which are now blinking very quickly; however, there have been complaints that they aren't holding up, so I'll keep you updated.

Sky Crowley

| Sep 03, 2021

These lights are a great deal

4/5

The lights are excellent value for money because they work well and are inexpensive when compared to other brand-name alternatives. Because the housing soldered to the light wire is so thin, installation is a little tricky. It works flawlessly and looks fantastic once installed.

Harlem Randolph

| Mar 08, 2021

The brightest lights possible

5/5

Prices that are reasonable. Excellent product with a lot of shine. It took only 5 minutes to complete the installation. It was a perfect match. Prices that are reasonable. Exceptional supplier. It was a perfect fit for my 2019 FLHTK.