Smittybilt DRS-6 Roof Rack Bracket Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As part of it, Hello 6 was available
It's for sure that they This is a cheap replacement for my Yakima round bar on my vehicle's factory oval bars and it works great. Everything seemed to work fine.
The one I got came with six. The item was purchased
Between the bolts are about a third of an inch
Selected User Reviews For Smittybilt DRS-6 Roof Rack Bracket Kit
The Thule Rack bars on the Chevy Silverado cap were able to accommodate the Defender rack on my Wrangler. I did not have to buy another truck rack because I could use the one that I had. It is the bracket kit you need if you plan on using your Smittybilt racks with vehicles that have other roof rack bars. I only have a beef with these because the U-brackets are too long The bolts protrude higher than the rack bars of the Defender, so you can get caught up on the protrusion when moving stuff around on the rack. The amount of angst is not enough to pop a hole in a spare tire, but it is enough to make you angry. There's a chance I'll grind them down by three millimeters.
As the loop has a larger diameter than the round crossbars of the rack, it glides on and off easily. For the gap, I had to fill it with a very hard foam rubber. Now hold on to your hats. Due to the fact that these are the only mounting brackets I could find to mount my Smittybilt rack to my Yakima cross bars, I am happier with it than the review suggests. Your rack sits high off the crossbars when you use it. There are six of these in the set! It seemed like this was a price per each based on the listing.
On its top, the Traverse comes with a strange set of rails that can't be filled by Yakima or Thule towers. It is necessary for me to mount two Thule Boxes side by side on the top of my car, so the Smittybilt clamps help me achieve that. Their construction is solid and their quality is excellent This was done. As far as adjusting the boxes, the only adjustment I made was to saw off about an inch of screw heads and a bit of the nylon bolts so that they would There is a U-shaped hole in the middle A lot of the screws and bolts sticking out of the top of the bars during assembly are long and shaped. This will allow the boxes to hang evenly from the bars when they are cut. These clamps are a great cheap solution and a great purchase, although they are not supported by Yakima, when i consulted with them. It's a five-star rating!.
These rack brackets were perfect for my custom made roof rack, but I needed a once I used an inexpensive rubber mat to serve as a spacer, they worked incredibly well. My only issue is that one of the brackets has a little rust on it despite it having been on my rack for about three.
You can expect threads to corrode after a while.
A rack for my Hummer H3 was on my wish list. During a deal I could not refuse, I found the Smittybilt 45654 at an affordable price. Despite searching everywhere, I was not able to find any factory mounts for my vehicle or rack. Despite over a thousand miles of use, these cross bars fit perfectly with my factory cross bars.
I have to modify the bottom plate because it is too thick for my needs. Don't decide to buy impulse buys like I did, measure before purchasing.
There are no problems with it. The majority of the parts are made of I will have to replace the housing on two wing nuts myself since they came loose. The customer service team was unable to provide any assistance since the kits were sent prepackaged.