LTSPRO 3 Color Temperature (2700K, 3000K, 4000K) - Led Task Light by NSL-9 inch Black Finish - Dimmable Under Cabinet Lighting

They have installation issues, but afterward, these work well. There are two brightness levels and three color options that I like. I am pretty satisfied with the construction quality. It has some issues with installation and parts. The lamp is rated 5 stars, but the parts/installation are rated 3 stars. A score of 4 stars is considered a good score. This is due to the connector supplied in the cable. As long as the screws are installed using the normal method with their heads down, the ends of the screw heads will hit the bottom of the cabinet before tightening the cable (Romex) so it is held in place There is, in essence, too much length in the screws. In addition, the connector is too thick to allow the lamp to sit flush against the cabinet bottom any way you place I spent a lot of time on the first install trying to figure out how to do this. The idea that a clamp would be provided that was not coordinated with the light thickness did not make sense to me at all It was true, though. Trying to make the lamp look more stylish, I used a low profile cable connector I had lying The two lights could have been addressed as well, but I didn't get around to it. My first draft was done, so I felt no need to redo it. As for the clamps, I used a lower profile to make them less noticeable from a low viewpoint, but it shouldn't matter in the real world since no one was likely to notice. In addition, unless the wiring chase cover has been removed and you have enough slack in the wire, you will likely not be able to wire the lamp without removing it. Even if you do remove that cover, you won't encounter too many issues. As I installed the lamp on the second occasion, I pulled the wires through, tightened the clamp, secured the lamp to the cabinet bottom, and then made the final Quite a few people have found this to be helpful. It would have been much better to use a middle screw on that panel, as it bulges every so slightly in the middle. As a result of my electrician using 12 gauge wiring in the circuits, the installation was more difficult than anticipated. However, I cannot fault the lamp since it would have been much easier to work with 14 gauge wire. It is also possible that my slight bulge in the wire chase cover is caused by this thick wire.

Landen Reyes

| Sep 11, 2020

In this regard, the fixtures are as described and they deserve a 5 star rating. On their (in)comparability with my own wiring already in place under the counter where these fluorescent fixtures are replacing, I took away one star. As the wires were too heavy gauge for these fixtures, I had to cut off the ready-to-slide-in fittings and add standard wire nuts, as the wiring I had in place had been configured to come into the end of the fixture as is typical with fluorescent undercounter lighting. In these fixtures, the wires should come in the middle of the In order to make everything work, I had to do some creative wiring. I don't see it as a huge deal, but you can't just connect it up. It's incredible how much light comes from those fixtures, even at their highest setting. Actually, I was surprised at how much I enjoyed the light coming from them. In fact, I recently have plans to install more of these same fixtures elsewhere in our house, where I want to replace our old fluorescent fixtures with better LED fixtures, so now I'm aware of what's involved. The one star I would have knocked would have been my preference if I could only knock half a star off. I wouldn't give it five stars, but it is pretty.

April Baxter

| Nov 09, 2020

In a nutshell, It's a nice touch to have in It has a low profile that is recessed underneath the cabinet and has a three-pronged handle The lip is one quarter inch thick. Romex 14/2 will only fit in the connector if you are using Romax. With the longer light fixtures, it is easier to tuck the wires underneath the cap. However, with the 9 inch light, I had a difficult time closing it because the connectors don't always have a lot of room where all the electrical components are located. The customer was extremely happy with their purchase, and I would recommend them to others. Despite the fact that one of the boxes had been opened and crushed, the fixture itself was not damaged, but The company failed to respond to my request and I never heard from them again.

Sara Hansen

| Nov 21, 2020

It's hard to believe how beautiful these lights are! I searched hard for a good hardwired under cabinet Led light set and these were great, no complaints. They are easy to install with two options to daisy chain them together, which is nice. They have multiple color options and are nice and still fairly low profile.

Miley Sandoval

| Dec 23, 2020

I purchased two of these to use under the kitchen cabinets, and they stand up to the test. This is easy to mount, and it comes in three colors, which is a better feature than I expected. In order to use these new plugs, I bought replacement cords since the cords were 6 feet long and I only needed about 8 inches.
You can rotate the plug so that it turns 8 different ways, so I arranged it so the cord is coming out of the top after it has been plugged in, making it look cleaner. There's only one thing that I would have liked to have done -- I wish I could have purchased a black light and used a white cord. It would have looked better against the backsplash, but that's another matter altogether. We were extremely pleased with the quality of our.

Blair Benson

| Jun 08, 2021

It is unclear why they couldn't use a smaller lamp shade like the cord did.

Beckham Perez

| May 14, 2021