EShine Interconnect Cable - Male to Male - for LED Under Cabinet Lighting with Wire Clips for Comfortable Installation (3.3ft, Black)

There is a very short pin on the plug that does not fully fit into it, which results in the power supply having a very unstable voltage. The answer to my question as to whether they have cables with a 10mm pin as this one is only a 7mm pin came back saying the pin is actually 9mm implying I was lying. As you can see in the photo, this is definitely not 9mm (or 10 for that matter), or even 10mm for that matter, so I am not sure what rule they are following,.

Michaela Morse

| Aug 16, 2021

Under cabinet lighting has been on my wife's wish list for some time. My research led me to choose these ESHINE lights from among many other light sets. In my case, I connected the lights and I laid them out on counters and held up the lights under the cabinets to help me decide how best to mount them. I then installed mount screws for each bar and then disconnected the light cables. I then disconnected power and all cables and neatly installed them under and through the cabinets (I drilled 3/8 holes in four of the cabinets to route the cross-over cables) which connected the two light bars on the left cabinets across the sink to the four light bars on the right side After going through the refrigerator, I neatly ran the power cord behind the refrigerator and then connected the appliance This is the end of my writing. Due to the fact I took my time and performed the installation as close to perfect as possible, the installation took me four hours. As long as the entirety of the system was not visible from the kitchen, I could have done it in less than an hour if I had not been so concerned about the neatness and visibility of the system. This is the most important. I bought these lights for my wife. She loves them. There is nothing she loves more than. It does not have a touchscreen. It's great to be able to dim and go bright at the same time. Under cabinet lighting is of interest to anyone searching for it. The pictures are awesome! Full brightness is very bright and white, but not as overwhelming as some full brightness levels. The lights are excellent. I highly recommend them.

Sergio Pittman

| Jan 09, 2021

A lighting fixture under a kitchen cabinet. I did a lot of research and found most of the lights were thick enough that they could be seen from adjacent rooms. A set of these is extremely thin and can be recessed into the front of the cabinet, making it impossible to see them. My first step was to drill holes between the cabinets so I could easily run the cable between them. There were plenty of self-stick clips included in the kit to keep the wires in place and out of sight. It is pivotal to have the 3M adhesive strips installed and drilled pilot holes to ensure that the cables never come loose. I used the included screws to install the 3M adhesives. By the end they are hidden away, provided you provide just the right amount of light, so the shadows are not too dim and the highlights are not too bright. If you hold your finger under the IR sensor of the 1st strip, you will be able to dim the lights. I went with the 3000k warm white light and it is fantastic, so glad I did not go with 6000k cool white. This is not yellowish in any way, just a warm natural glow.

Wyatt Banks

| Jan 30, 2021

Using these lights under our cabinets, we lit three different countertops, all of which were controlled by a single switch. Bright daylight bulbs, good for task work, dimmed to make a very pleasant nightlight, are well suited for bedroom lighting. By drilling a few holes in the cabinets, it is easy to insert lighting in the desired location. According to the instructions, make sure the control module is mounted at least 4 inches below the cabinet lip. Dimmer settings will be hard to adjust if this is not the case.

Pablo ASHTON

| May 19, 2021

My stove has two lights on opposite sides of the stove, and I wasn't sure how I was going to connect them. Thanks to their interconnect cable, I was able to connect to their server without a problem. It was easy to string cable between the light on my left side of the stove and the light on my right side. Within my kitchen cabinet, there is an electrical outlet above my microwave. I drilled small holes inside my cabinets to make it easier to connect all the parts.

Charli Matthews

| Jul 06, 2021

Installation was very easy, and the lighting bars were of high quality. There are only a few things I wish were included in the kit, most notably the extension cables. After I have my lights installed, I had to buy an extension cable since I can't reach from the underside of the cabinet to the top of the cabinet without the Eschine is highly recommended. I bought Albrillo, which comes with a switch that turns it on and off as well as All of EShine is built into the main A MUCH BETTER DEAL!.

Kole Ford

| Jun 29, 2021

I was looking for something to light the kitchen countertops under the cabinets as the regular light is This product has been a great success and the ability to control the brightness on the countertops at night has been helpful. My wife and I do a lot of computer work at night in our home office, where the lights in the kitchen were so eye-catching. I decided to get another set for the office. Light in the right amount. This product offered by shine has a lot of different cords and connectors to deal with any lighting issues you may have. I enjoyed using this product and would buy more if they were utilized in other applications. It is very well constructed, and I highly recommend it.

Miley Rojas

| Sep 11, 2020

Buying this item completes the set that I purchased previously. Lights like these are ideal for beneath my kitchen cabinets. I was able to install it and it worked perfectly.

Dylan Clements

| Mar 21, 2021