* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black

M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black

M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black
$ 5.45

Score By Feature

Based on 341 ratings
Easy to install
9.18
Value for money
8.68
Adhesion
7.78

OveReview Final Score

How Our Score Is Calculated

Product Description

This door bottom fits doors up to 36 inches
Installs new vinyl inserts in place of worn out ones
The bottom of an L-shaped or U-shaped door can be fitted to this part

Questions & Answers

Can you tell me how thick the piece is?

Three eighths of an inch is the longest of five rubber tines, but it mashes down to about a quarter A very tight seal has been achieved on my door using the Dennis Premium door bottom I purchased from Menards. There is no play in the metal bottom guides because the rubber strip on the Dennis product fits snugly in them.

What is the width of this vinyl replacement threshold and will it fit the metal threshold I have?

Vinyl replacement I have is only one inch wide and 36 five eighths long, and has the item # 25756. As long as the slot it slides into on your metal threshold is no wider than 1', this should fit in it.

According to the product description, it has a 28-inch diameter, but in the advertisement it is described as having a 36-inch diameter. Do you know what it is?

36" by 15/16" is the size of this item. When I purchased it, it was listed as measuring 1 1/8" or 1 1/4". I was a little concerned about the width because there seemed to be a lot of play when I inserted it in the metal frame, which gave me the feeling that it could fall I crimped the metal on both ends when I installed it, and it has not caused any problems. As a result, the original rubber would wear out much more rapidly because it was too tight. Having three of these on hand at the price listed actually cost me less than the cost of one There is a status update.

Can you tell me how wide it is? An image showing 36" in length has been displayed. ?

I had to trim the length of the metal channel on the bottom of my door, as it is 1" wide. It slid in snugly, but I did have to adjust the width. After the original lasted thirty years, I had this for about a year, and it worked perfectly.

Selected User Reviews For M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black

This component is 1/16" wide, but nowhere can I find it listed
5/5

I had an internal door to my attached garage that was 1/16" wide. It fit perfectly into the sweep bar. My opinion is that it's holding on for dear life against the threshold, but it probably just needs a little settling in.

Abigail Larsen
Abigail Larsen
| Nov 20, 2020
This was a door seal I needed to replace on a slightly older door, but unfortunately, it wasn't the one I needed
3/5

We have our old seal on the right and our new seal on the left. The new seal does not have the same width as our old one and therefore cannot fit in the 'rail' that is within.

Elina Vargas
Elina Vargas
| Oct 30, 2020
I changed the battery in less than a minute
5/5

An old seal underneath the door was causing problems on a new house I bought. In both directions there was light to the outside and it was wide enough for a mouse to get in, so I saw it and I wasn't sure if I needed to replace the whole threshold, but when I inspected my door closer I found a track so it was This part was easy to find since I pulled the old one out with pliers and slid this one in. I might have known what it was called in the first place, but I found it and found it easy to replace. We only spent a few seconds on that!.

Journey Barry
Journey Barry
| Jul 21, 2020
There was a rather crucial part of this bottom door shoe that went missing - The part had disappeared when the door was painted last
5/5

Saw it missing during the cold winter weather, and discovered it was the perfect replacement. Had to take the shoe off to push it into place with pliers. I don't have a problem with this product, it's just how the shoe was made-- You will no longer have any drafts to deal with! A satisfying seal is provided by the door.

Rowan Moyer
Rowan Moyer
| Mar 15, 2021
There is not enough detail in the It allows me to work with 1/16 inch), which is what I wanted
5/5

This mug is 7/16 inch tall and a little over 36 inches long.

Autumn Tran
Autumn Tran
| Aug 23, 2020
I was happy with the result
5/5

The information I was seeking was located here. I found the installation to be a little tricky. I needed a wider material for this, but I could give it some leeway because of the material. It was a good value for the price. As soon as the device was in place, I cut it down a few inches.

Bodie Curry
Bodie Curry
| Nov 23, 2020
It is easy to install
5/5

The old sweeps were popped out in less than ten minutes and the new ones were measured, cut, and inserted. There was no line and pricing was comparable to the local big box store, minus the exposure and the lines.

Ensley Haley
Ensley Haley
| Mar 07, 2021
The width is too small
3/5

It was not 2 inches wide but barely more than 1 inch in cross section when I received it in a package marked as 25756. In my application, this strip is too narrow and wide. It is described as being 25 inches wide, but I cannot use it because it is only 25 inches wide. There is a possibility that the item wasn't as wide as described, but it may have been mispackaged.

Evie Silva
Evie Silva
| Dec 16, 2020

Related Products For M-D Building Products 25756 M-D Replacement Threshold Insert, 36 in L X 2 in W, Vinyl, Black