Henson Swing Gate Wheel Gate Caster for Vinyl Gates Heavy Duty Spring Loaded, 3.9-inch Dia, White

The width of two

Prefabricated gates were attached to the one I attached. A main panel of the gate was hollow, but the surrounding panels were solid Unlike a regular vinyl extrusion, the gate frame was not just plain and empty. The frame was attached to me. Yours is certainly hollow there too if you know it to be so- If I were you, I would reinforce the wall with There is a greater diameter of screws- If there were lumber inside, it would get enough purchase. If possible, it would be great to have lumber inside. When I mount the wheel, I clamp it firmly in place - You can move the gate at any point along its travel range. Prior to drilling holes, make sure they are adjusted. When I realized the wheel came off the ground, I realized there was a slope. The data has been adjusted downward A wheel is now holding it up so that it does not sag. My friend showed me this gate and I decided to buy it The one he bought on Amazon is meant to correct his sagging issue This product has a heavy gauge metal finish that I find attractive. It is well worth

A hard rubber wheel with a diameter of just under 4" is on the skateboard. When the spring holds the gate up, it exerts a downward pressure on the wheel, which will cause it to push down while passing over cracks. It will likely be unable to roll smoothly over the cracks. I am sure it will work, but it may cause noise to rise through When it hits imperfections in the surface, the mine makes noise but rolls over cement slabs quietly.

In both right and left-handed gates, it works, but the side of the wheel on which it turns depends on which way the door opens.