* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
Shoreline Marine 3-Piece Super Bow Roller Poly (3-Inch)

Shoreline Marine 3-Piece Super Bow Roller Poly (3-Inch)

Shoreline Marine 3-Piece Super Bow Roller Poly (3-Inch)
$ 19.83

Score By Feature

Based on 943 ratings
Easy to install
9.73
Sturdiness
9.49
Value for money
9.28

OveReview Final Score

How Our Score Is Calculated

Product Description

A 3 inch bow roller is available
Designed with 3 pieces to reduce friction and drag, making launching easier
Neither oil nor gas nor salt will affect it

Questions & Answers

Would anyone be able to tell me what diminutions to use?

Despite the fact that the roller they sent me says it is three inches, the inside part is three inches in diameter. It is roughly 75 inches long and the total is around 7 inches. I am 25 inches tall.

Likewise, I also had trouble getting it to fit the Surely, if I saw off the area on each end that sticks out, it will fit. Is that possible?

This 4 inch one is probably too big for your trailer, so I don't think you should have bought it. Fit should be possible with the 3 inch model. The only sizes available are these two.

Can you tell me what size the locking nut is? There was no remote in the box! ?

Then, go to the hardware store to compare the bolt to the hole in the wall. It would be best if the nut was self locking.

Approximately 6 inches are measured from end to end on my bumper. There are three or four inch options for all of these. That's how you measure something, isn't it?

Bow rollers like this one are used in arrow making. It is typically three to four inches long and fits between two flat mounting brackets that have been drilled for the mounting bolt. This model has an extra piece of protective plastic covering the outside of the mounting bracket. There is usually a roller near the trailer winch where your trailer is attached. It is imperative that the bow eye is positioned close to the bow roller, which acts as a stop, when the boat is being hooked up to the trailer. Depending on where you live, the roller you need may be a keel roller or a typically used for the lower portion of the trailer, where the boat frame rides over the boat hull. To determine the correct size of any roller, the mounting brackets must be added to the shaft hole size. This usually results in a roller length of 5, 8, 10, 12" or beyond with holes for either a 5/8" or 1/2" If you would like to speak with our customer service department, please call 800-455-8700 There are 334 If you need assistance determining the type of style you require, please call 2661 ext 3619. We would appreciate if you could send us a picture of the roller you are trying to replace so we can better understand what you are talking about.

Selected User Reviews For Shoreline Marine 3-Piece Super Bow Roller Poly (3-Inch)

The quarter inch doesn't seem like much, but actually leaves the metal exposed and able to be accessed
3/5

There is no true 3" roller in this box. Would have done better if I had listened to In the center, there is only a 2 inch diameter. The metal is exposed by a quarter inch, and although that may not seem like much it actually allows the boat to be hit. To make this fit on my trailer, I need to modify it a bit. It would be a waste of money to buy this product I can't make out the number on my trailer, unless it has Gap of 75" in the middle.

Lena Jenkins
Lena Jenkins
| Dec 03, 2020
I made a little improvement to make it more convenient
5/5

I think this item will be useful for the purpose it has been assigned. It has a lot of people complaining about it not being true size, but it works very well for what I need. There are two extra washers (one each on the interior sides between the cone and the metal base) to ensure that the rubber cone moves freely when the boat is in position. This was a very enjoyable read for me.

Garrett Burke
Garrett Burke
| Nov 05, 2020
Actually, 3" rollers are not that big
3/5

Bow rollers like this one are pretty nice. The quality is just fine. This roller has a hollow center, so it is not very sturdy. It is supposed to have a 3" diameter center roller. There is no such thing. Despite its small size, it is only 2. 5" in diameter. When the conditions are right, it could permit the boat to hit the metal part of the bracket.

Dayton Dalton
Dayton Dalton
| Jan 18, 2021
There is no such thing as a three-inch roller
4/5

As a result, my first error was not finding out what kind of shaft it was. It was 1/2" compared to the one on my trailer, which was 3/8". In order for the bracket to fit, I basically had to drill out the holes. In reality, the roller is only 2 3/4" wide, not 3" as advertised, and the gap between sections is larger. It is not a huge deal for my boat but could be for someone else's. I know every boat is different, but it seems to work for my boat. The new roller is a huge improvement over my old one. Until time tells if it is well made, it seems like it is well constructed.

Lyric Bennet
Lyric Bennet
| Aug 28, 2020
There are no marks on this product, so it's very I couldn't be happier with how they fit and how easy they are After that, I need to clean the black rubber marks left on the bow by the old roller!
5/5
Magnus Jacobson
Magnus Jacobson
| Feb 19, 2021
It's just so much better than the stock option
5/5

Although these trailer rollers are much better than the stock Tracker 170 trailer rollers, the gaps between them In order to keep the trailer bracket from touching the roller, the roller is tall enough. I love the smooth rolling on and off of the shoes.

Maximo Bullock
Maximo Bullock
| Mar 08, 2021
I think she's a A big YAY to me! A big one at last! Please pay attention to the specifications of these rollers before you buy them
5/5

It is also important to consider the size of the center roller, the end guides, and the overall dimensions of the parts. You should not buy if the information shown is too little. I found this one to be effective. The rest will be returned. Thank you.

Sawyer Ferguson
Sawyer Ferguson
| Oct 08, 2020
Rollercoaster to die for
5/5

In place of my old rubber roller, the shoreline roller was purchased. It has been stated that some of the reviews indicate that it is too small. In order to allow it to move when used, it is a bit smaller. The metal bar that holds it on the trailer was bent a little so it was a little more tightly squeezed onto the trailer. As a whole, I am really happy with this purchase.

Creed Ibarra
Creed Ibarra
| Jan 20, 2021

Related Products For Shoreline Marine 3-Piece Super Bow Roller Poly (3-Inch)