Hunter Industries 3 Pack 458200 WRF-CLIK Wireless Rain/Freeze Sensor, Combo (Includes Receiver and Transmitter), White
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
That item is not carried by us, and I was not able to locate the SKU # for it on their website either.
I don't know, because I have a sprinkler that runs at night. In fact, I know the water will not be delivered if it detects rain or freezing weather. As a result, I would think it would disrupt any ongoing watering too.
That will be the case. *Thank you for your kind words
Selected User Reviews For Hunter Industries 3 Pack 458200 WRF-CLIK Wireless Rain/Freeze Sensor, Combo (Includes Receiver and Transmitter), White
When I bought my first laptop in 2006, it was a MacBook Pro. After finally expiring in 2018, the legislation was repealed. SprinklerPartsWholesale supplied me with one to replace it. There is no freeze sensor in their WRF (as there is a WRF for freeze). other books I bought was not WRF but it was exactly what I wanted. It simply required you to remove the previous one, reconnect the new one, push the reset button, and everything was fine. house, there was an all green display, and outside, where it was 20 degrees F, the display switched to red after a few minutes The watering should be turned off. I have been able to connect to Rainbird's ESP without problems (Also installed in 2006) LX Modular.
My irrigation system was installed by a contractor, and I need to be able to remotely control it. Also, be able to determine when it was not appropriate to water the lawn based on the forecast. During my research on Hunter's website, I discovered this device, and I decided to try it out. When it arrived, I spent a lot of time attempting to understand the instructions and eventually it worked. It's hard to install or setup because the instructions or process are difficult. It was necessary for me to contact Hunter Industry in order to get more information on how to setup this controller. It was a pleasure dealing with the customer service representative. Everything had been said and done in the end. Worked for me. Even when the sprinkler system is already in its programming cycle, it keeps the system from watering. My only regret was that I did not purchase the flow controller to monitor the flow rate, just in case the line broke or something like that.
In this sensor, the mobile antenna was replaced by the antenna hanging from the cable. I was able to set up and install the new unit with no issues. A few minutes were all it took. I do have one complaint, which is that the new wall receiver mounting holes are closer together than the old ones. A patch had to be put on one of the existing holes in the wall and a new one had to be drilled just above it to anchor the board in place. Because they had already reached the threshold, it would have been better if the new unit had been the same as the old to avoid the additional.
If you install it, don't do as I did, and don't make the same mistakes as me. In order to replace an old wired sensor that didn't work, I replaced it with a wireless one. Without knowing that the wire connected to the controller was under ground, I just snipped the wire from the old sensor. The sprinklers were not meant to work since that was the ground for the system. In a matter of minutes, an irrigation technician knew what to do, and the problem was solved. Additionally, you should make sure that the sensor jumper across the two SEN terminals in the controller is removed as the directions direct.
According to the new transmitter that I got in 8/2018, I will find out in late 2028 if I need to purchase a new transmitter or have to order the whole kit all over I would personally prefer the battery to be able to be replaced.
Replaced it with a similar device that was easy to replace. I stuck to Hunter because the first one had worked so well and lasted so long.
I liked the fact that this was delivered on time, priced well, and By putting this in place, my sprinkler will not be used in the rain or after There is also freeze protection for sprinklers (I inserted the sensor into the freezer for a short while, and in no time it indicated the sprinkler was blocked. Once I set it to "defrost", it turned on my system again). It will be my pleasure to work with.
I purchased this to replace a wired sensor that had a buried wire underground and had stopped working. We are very pleased with the combination freeze/rain sensor, and the setup was simple and straightforward. Even the "pairing" process was easy to follow and use with the included directions and hardware.