Frost King ZP1 Screws and Clips for Furniture Re-Webbing, Silver, 20 Pieces
Score By Feature
OveReview Final Score
Questions & Answers
The washers do not need to be used Unlike a standard screw head, the screw head has an attached wide back that is used
As far as I know, I’ve only used them with aluminum folding chairs and/or lounges.
In fact, the pointy end of the clips is designed to fit into holes in the aluminum tubing of a lawn chair.
There is an instruction manual included with them. The clips and screws I ordered arrived, but I decided to use the screws instead. There are some challenges with using the clips.
Selected User Reviews For Frost King ZP1 Screws and Clips for Furniture Re-Webbing, Silver, 20 Pieces
The flat head screws would have been more obvious to me if I had noticed them earlier. I think it would be a very bad I suggest using screws with a cross recess head at least. In trying to drive these into aluminum, the bit has slipped so much that my hand has been gouged in half a It would have been much easier if I had just gone to Lowes and purchased cross recess head sheet metal screws.
It was not that they were not quality, but that I had to return them. Re-read what I wrote earlier Our previous chairs had webbed legs and we As a result, I had to return this set because it required other kind of hooks due to the hole in the chair. Other words, they couldn't be used because the holes were too small. However, I find them to be really nice in other chairs I have re-upholstered A webbed structure. Re-engaging your screw should be as easy as checking the hole size and using the right item A web page. This or screws are needed for most chairs.
It has been repurposed as a folding lawn chair This page has been webbed multiple times. A rocking lawn chair like this is very comfortable. It is impossible to screw these screws and fasten the chair if most of the holes are too wide. Any weight put on the newly webbed lawn chair caused most of the new screws to pop right out. It was frustrating that the threaded part of the screws was too narrow, not to mention a little short. I won't be buying.
Then I decided to take a chance and buy screws (only) to replace the nylon strap rivets on the patio chairs that were broken. The screw threads are too small for 3/16" diameter screws, so I initially thought they might hold better. A hole.
Due to cost differences I decided to not do a project that would cost half of what I had paid for these items to return to US Postal Service, and therefore I lost.
There was a large difference between these screws and those I normally use. They will probably be put to good use on some other project, but that is a lot of money down the drain for screws that aren't up to the task.
It is easy to tighten the screws. The fact that they are straight screwdriver bits didn't excite me. If I could have chosen, I would have chosen a star or phillips head. It is better to have a In chairs without previous screw holes, a drill bit with a 5/32 diameter was the best.
We used it to replace metal clips we had on a rocking chair on the porch that we planned We have to drill holes in the metal chair and use the screws for holding the new webbing in place to prevent the metal clips from rusting. Once we weave the new webbing through the chairs, we will not use the metal clips. I was able to get these screws for less at the hardware store than I would have paid at the.