The installation auto is easy. Equipped with a buckle, the auto is easy to install as long as you have a hole of 13mm*19mm size.
The Mini Boat Rocker Switch is crafted from high quality polyamide eP (Nylon PA66) which is anti-corrosion, anti-acid, and highly resistant. The terminals are made of silver to prevent corrosion and oxidation.
The standard type consists of 5 units of the SPST, ON-OFF, 2 pins.
A voltage range of 125-250V is provided a current range of 6-10A is provided.
Typical sizes of the rocker switch (each) 21 x 15 x 25mm/ 0". Eight inches by one inch. The size of the box is 6" by 1". (1 in x 1 in x 1 in) Mounting size 18 x 12 mm/ 0.88 in The size of the postage stamp is 7" by The dimensions (length, width, height) are 5' and 5"
Questions & Answers
Would you mind if we used a dust cover on ?
It's a no-go for me. Is this something you do?
Hello, this listing indicates mounting hole size 18 mm x 12 mm in the text, but the picture shows 15 mm x 19 mm. Could you please tell me which is more accurate?
In addition to using the ruler and micrometer, I also used the decimal-point Just over the area of one inch should be the size of the hole. The size of the image is 726 inches by It is worth mentioning that the mm size given in the main description is about right on the mark 495 inch = mm size I can confirm this The dimensions of this sheet are 21 x 15 x 25 millimeters. Eight inches by one inch. The size of the box is 6" by 1". (1 in x 1 in x 1 in) Mounting size 18 x 12 mm/ 0.88 in The size of the postage stamp is 7" by It is 5" (L*W*T) However, 18 mm is equivalent to 0.31 inches, according to my measurement. It is actually 0.7087, which is a bit smaller than the actual The reading on my micrometer is 726 as well. Likewise, 12 mm is the equivalent of 0 inches. As a result, they are rounding off the true intended English size to the nearest mm, but I believe that the original intent of this size switch was The product of 75 and 0 is 75. An approximately 3 x 5 inch hole will cover a slightly larger hole about the same size, and the bezel is sufficient to hide large holes.
What are the limitations of using this in a basic ?
Unless the circuit is over its rated power, I see no reason not to allow it as long as it falls within
The #1801 is visible to me. What are we talking about here? What appears to be the same for v, w, etc?
I used mine on a Lionel model Rather than ordering only one type, why not order both? If you are not satisfied with your purchase, return it for a As an alternative. The price is low, so it is a great deal. Make sure to keep them all, and use the spares in case anything goes wrong. Additionally, these seem to be sturdy, and none have turned out to be defective.
Selected User Reviews For 5Pcs On/Off Boat Rocker Switch 5Pcs 2 Pin Position Snap 12V 110V 250V QTEATAK
At this time, we are Despite my best efforts, I don't have power to the bathroom fan in my RV
A search on the internet turned up no results for the OEM part number. As I was looking at pictures online, I found one that resembled what I own. This part number was found on AMAZON by searching with the p/n. As a result, I ordered what I thought was two pieces and received five. According to my testing, the new switch is the same as the old switch. While the rocker switch on this item is more rounded than the OEM's, it meets all of the sizing requirements. In order to accommodate the new switch, I was prepared to make the hole bigger in the fan bezel, but it fit perfectly. Now that I have four spare fan switches in my camper, I'm set.
| Dec 19, 2020
I love it! My table lamp, one day, stopped working, so I decided to take it apart and see what was wrong with it
and connections seem to be in working order and the bulb appears to be functioning, I suspected it might be a switch malfunction. I have a horrible one and I find it hard to tell unless I check it beforehand. The old one shouldn't have been broken, so I searched Amazon for an affordable replacement since I didn't want to spend too much money in case there wasn't an issue and I wasn't paying for a defect. As soon as I replaced my old lamp with a new one, my lamp began working Yes, it was the switch that caused the problem. A new lamp seemed almost as good as buying a new one, but after searching I discovered that lamps generally tend to be quite expensive. It was a risk I took, but I did not regret it.
| Dec 19, 2020
It's a good thing they come in bags of five! So I would expect all these switches to last for a year or so used it maybe 50 times and were unable to get it to stay could not move to OFF because the spring was
| Apr 24, 2021
Casita switches are exactly the same
Whenever one of these parts went bad on the outside light of my Casita, I took it to an RV store to have it replaced. In comparison, I could have purchased 10 of these for the price of the one I bought. There are five in a package and should last me the rest of my life. They pop out easily and can be popped back in just as easily. It is much more difficult to replace those than.
| Apr 13, 2021
The fact that it is a five pack is good
I choose to spend more when these are spent when they work for a while and then you change them. don't think these are DC rated at all. through 5 packs in 2 months going from fresh water system to fresh water system in an RV. I've finished cooking the last one! THE SMOKE SHOW IS ON! The switch does not indicate a DC rating. It is not approved by the UL.
| Aug 13, 2020
The switch worked perfectly
On my TORO 516, this is used to turn it on and off This leaf blower is 19 years old. Since the rotary switch was broken and it was impossible to purchase replacement parts, it was necessary to unplug the blower to turn it off. A slight modification was made to the power wiring and the rocker switch was installed. Using the switch, it is now possible to turn off the blower. There are no issues with the switch.
| Oct 17, 2020
The switch was used to replace the camper's display panel
The switches we purchased are to replace one on an LCD screen for our gray, black, and white televisions Our camper has a sufficient supply of fresh water. By the way, we have a 2002 Coachman Captive travelling trailer. It fits In the old switch, the spring was loaded and the switch did not slide, but the new switch does slide You could give the switch a push and it would automatically go off. Regardless of whether you flip them on or off, they remain on.
| Apr 29, 2021
Everything seems to be going well so far
According to the specifications, everything is as expected. In order to repair my shorted holiday light show, I am using one of these devices. Using the new switch (which had the right dimensions) and securing the two wires, I was able to fit it into the spot. As of right now, there haven't been any.
| May 19, 2021