Swordfish 8034 - Metric Alloy Steel Hand Threading Tap Set of 3 pcs Bottoming Plug Taper Uncoated Finish Square End M3x0.5
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The taps that I have are 10 m long and 1 m wide. The numbers 0 and 3 and 1 are the same. Overall, the length of the thread is 16 and it is 1 inch long. The taps are very good
There is no carbon steel or HSSE in this steel, it is an alloy steel
There are three of these tap sets in my home Ten 10mm by one 1mm, and a twelve 12mm by one mm. A 25mm x 1 and a 12mm x 1 are used. Approximately 5 mm. Right-hand thread is used in all three sets. 95% of all taps and dies made in the United States have a right-hand It is rare for threads to be made on the left. The thread should be in the right direction! The author is Tom B.
Selected User Reviews For Swordfish 8034 - Metric Alloy Steel Hand Threading Tap Set of 3 pcs Bottoming Plug Taper Uncoated Finish Square End M3x0.5
When I needed to tap a hole, I used a H-shaped cutter My wife and I bought these multi sets with lifetime warranties. Then, after spending quite a bit of time trying to figure out what to do with these two holes and almost destroying the other two, I decided to buy this set of three (you need three taps for the same hole, not those sets with one tap These taps are excellent and cut like a dream. I would say that it took a couple of weeks for them to arrive, but it was well worth the wait. The drive took me 15 minutes, I went through 6 holes in 15 minutes, and it was a pretty enjoyable experience. An important part of success is having the right tools.
It did the job when I needed a blind hole to be threaded in a forged steel piece, and I only used it once.
There seems to be a difference in diameter between them, as the first one didn't go in, but the second There might just be a taper going on. Regardless, it did the job I needed it to do.
Good product, good price, but the tip on the bottoming tap had to be ground down Is that true? What's the point of that? choice in this size is a wise move.
The taps were precisely what I needed for me to finish the project after crossing treads on another project. They were quickly delivered, and I could complete the project without trouble.
It's nice to have all three. It is a pleasure to work with.
On metric motorcycles, this is used to clean up boogered up threads.
I don't think this is that bad. It will do the job but be careful when they bend or move in the.