Aokin 3D Printer Heat Bed Springs, 8mm OD 20mm Length Compression Mould Die Springs Light Load for Creality Ender 3/Ender 3 Pro/Ender 3 V2/Ender 3S, CR-10/CR-10S 3D Printer, 10 Pcs
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For Aokin 3D Printer Heat Bed Springs, 8mm OD 20mm Length Compression Mould Die Springs Light Load for Creality Ender 3/Ender 3 Pro/Ender 3 V2/Ender 3S, CR-10/CR-10S 3D Printer, 10 Pcs
In the beginning, the springs that I used to level my 300x300mm bed were just a little too small and I found it difficult to level the bed perfectly. Taking a dip in these springs was the right move. The 10 points needed to be 8 out of The tension of these leaves me confident that a heated bed will be leveled. In case of a loose spring, the bed might move slightly during printing, which can result in uneven printing. The right amount of stiffness is present in these. This review may be of value to you if you click the "Helpful" button below if you find it helpful.
Better than stock at holding height. There seems to be a better foundation for the bed. Since I last leveled over a month ago, I've been able to remove the ice. Nevertheless, they needed a couple of shims to be tall enough so that my setup was effective. These springs have worked great after the shims that are 1/16th inch thick on the bottom of each. These appear much firmer than the stock Ender 3 Pro Springs, and have flat ends which make them more attractive.
For the money, they are definitely Unlike me, I don't think everyone will need to use metal.
I expected it to work. Here's the cheapest route (at time of writing) to springs that won't leave you with 14 extras you don't need. The leveling was done every week, then I stopped leveling since I installed them over a month ago, and now I don't level anymore.
Using this printer surface balance system means he doesn't have to balance the printer every time he prints! I highly recommend this printer surface balance system! This is a decision you will not regret.
Ender 3 of the reality series.
It is a better upgrade than the stock springs on Creality 3D Printer. They are shorter than the stock springs, but they work great.
Adding an additional layer of firmness to a bed like Ender 3 is a very good idea. Nevertheless, ABLs are becoming more affordable, and the automation they can provide is helpful. I think these are great, but you might want to have a look at.
The advertised service was delivered I stiffened up my ender 3 bed right away. I don't think I need more than 10.