E-link 4Ch CCTV Video Multiplexer Over 1 Coaxial Cable for Standard Analog Cameras (HD-4ch-Multiplexer)

E-link 4Ch CCTV Video Multiplexer Over 1 Coaxial Cable for Standard Analog Cameras (HD-4ch-Multiplexer)

Name: E-link 4Ch CCTV Video Multiplexer Over 1 Coaxial Cable for Standard Analog Cameras (HD-4ch-Multiplexer)
Brand: E-link
SKU: 1242251
Price: 183.99 USD
Rating: 9.64 (8 reviews)

$ 183.99

Score By Feature

Based on 8 ratings

Delivery

9.30

Giftable

9.36

Satisfaction

9.68

Packaging

9.74

OveReview Final Score

How Our Score Is Calculated

Product Description

Over one coaxial cable, a 4 channel video signal for an analog camera can be sent

The transmission distance can be as long as

The volume of installation must meet a minimum requirement for the project

Installation is simple using the BNC cable

The coaxial cable eliminates the need for additional cables, thereby saving infrastructure costs (cost savings of 25-30%)

Questions & Answers

Do I have to buy another one?

Support is not available for HD cameras (HDCVI,HDTVI,AHD).

I need one set for 1000 ft. I am curious if this is for 500 meters or 100 feet, because the top says 500 meters. Could you let me know as soon as possible?

Regarding your questions, we would like to respond as follows The following is an example of a high-quality high-quality report

Is there a way to stop wavy lines on an ?

Without the box, you should test each camera separately to ensure it works normally. You can have loose connections or a weak power supply if you have this. To adjust the camera exposure, there is a small Philips adjusting screw on the end of the box. When turning a screw, notice where it is and watch for indications of its location You can only make a small adjustment, then wait for the improvement. If not, go the other way and tweak it further if necessary You may need to wait another few minutes. As a last resort, I would adjust this screw. I have two sets of these units, and both of them work perfectly. It seems that one unit is better than the other, but I switched them to see if it was the other unit. A line or blip is normal from time to time. I wish you the best of

To calculate HD run time, we need to know the total length. There is total distance of 1100' on both ends with length of 394' between them. Do you mean 320' between each end?

I would say yes. Input ===&gt 394' Coax cable and video multiplexer equals &gt This is egt This is egt This is egt The coaxial cable size of 320' is &gt This is egt This is egt This is egt This is egt In video multiplexing mode, the TX is equal to the RX This cable measures 394 feet long. There is a total running length of 1100 feet

Selected User Reviews For E-link 4Ch CCTV Video Multiplexer Over 1 Coaxial Cable for Standard Analog Cameras (HD-4ch-Multiplexer)

I love how well it works! It was necessary for me to return the first set of headphones, but the second set performed as desired

4/5

One of my outbuildings needed a new network, so this really simplified the process. In order to connect my analog cameras, I installed two coax cables years ago. In this article, I will explain how I consolidated two cameras in a coax cable, then use the other coaxial cable for my new digital network cameras and my In order to test these modules, I have purchased them from Amazon (from the internet) and connected a short piece of coax to them. There is an issue with network speed, and I noticed it was What matters is that. I will be able to use it for my purposes, and it is significantly less expensive than running new wiring.

Charlie Norman

| Dec 09, 2020

This is a good product

4/5

I used it a few times and they are quite good. The size of the units we have received has occasionally been different. It is impossible to hide large ones near the camera since they tend to be too large. Purchasing the small ones is much better, however it is not possible to specify size during the ordering process. It would be easier if the large one were to be replaced with a smaller one, as the smaller ones work perfectly and are.

Sariyah Green

| Aug 19, 2020

There is a problem with the software

3/5

Since I knew this would not include a power adapter, I did not order it. After I installed the unit and found the power adapters, the unit does not work properly anymore. My TX and RX units are separated by a 50 meter cable. steady video on the transmitting side, but on the receiving side the video on camera 1 is not steady, but the video on cameras 2,3, and 4 blinks The seller is in China and I tried contacting him last month, but along with everything else from China, I didn't hear back. My customer is upset and I have no resolution to this problem despite the fact that this is a toy.

Jayden Dougherty

| Feb 06, 2021

The software is very easy to use and setup

5/5

As a result, I am very happy with the multiplexer as it allowed me to use an existing cable to connect a second camera. Despite that, Chan 1 and Chan 2 do 1080p TVI, but Chan 3 and Chan 4 do not but overall I am happy with this Besides saving me time and money, it made my life a lot easier.

Holly CHARLTON

| Feb 24, 2021

This program works the way it should

5/5

This product does exactly what it says it would.

Zavier Daniels

| Aug 14, 2020

The specs are unreasonably high

4/5

The product was of poor quality and overstated in its We tried back-to-back at 190 yards of coax before getting one to work.

Hugh Caldwell

| Nov 17, 2020

The product works well for what it is designed for

5/5

How to set up security cameras.

Kaitlyn McClure

| Aug 12, 2020

The picture looks great on my analog set up

5/5

I think this item is excellent. A few cable adapters and we were able to hook it up I have power supplies in stock & ready to go It is true that I have 2 cameras on my DVR with only I recommend it.