Electriduct 1/2" Heat Shrinkable Braided Sleeving - 10 FT
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The color is currently black only.
Make sure that your 12 volt plug's outside diameter is set up properly. A sleeving for your plug or sleeving for the inside diameter of your plug should be much greater than that size. Having said this, I am sure you will need to measure the plug to check to be sure the size fits over 1/2" so measure the plug then see how good it fits.
This kind of plastic is a bit softer than the waterproof plastic and not completely rigid but not as flexible as that of the waterproof kind. Material material runs from the seam to the surface, making it more plastic than fabric.
There will be no way to use this product if you have any question that this product will not work. Tubing height greater than 3", one heavy wall tubing per size.
Selected User Reviews For Electriduct 1/2" Heat Shrinkable Braided Sleeving - 10 FT
In spite of the fact that braided smoothing is not symmetrical, it is. it to become the underside, if there is still room for it there, regardless what side your assembly is made off. I don't think there is anything wrong with it except that. The second smallest version is 2 millimeters in size. Around a tenth of an inch in diameter, and possibly up to 1 inch. The tubing comes in 9 in length but it loses slightly more length than a similar smoothwall. However, when installed to a smoothwall, it responds well and you don't have to worry about it. Unlike otherwise mundane cable assemblies, this stuff creates a distinct sense of class that never goes out of style. I would have loved to have had a glue on board. The line version is lined!!.
I think it is safe to state that size was stated, but not weight (left side). I used this as a layer in my car to protect my harness, which worked really well and helped prevent chafing. Without heat, I shrunk it rather than using a hair dryer. We ordered three more sizes for myself because of how excited I was.
After installing the risers I cleaned up the electrical that was coming down them with this product. As always the shrink rate was good and the product looked great. I am going to use this on the FXR to clean out some other harness problems.
This product removes wiring harnesses from the engine bay and keeps it tidy. As a braided type of sleeving, if any wires need to be clear, it expands a bit during installation, which is handy if there are small wires in it.
Hopefully I found that somewhere else before. There's no need to worry about a little stretch to the wire harness, it is perfect. Now you can really think of ways to make the wire harness look great for any occasion. As I have observed, they shrink a lot.
Getting smooth is a challenge. We can't shrink evenly because it acts like a magnet. The vehicle will take a lot of heat. Having ridges will also cause the crease to rise from being flat to being rolled over.
After trying this shrink wrap twice, but failing to work for me, I'll use the heat shrink wrapping the remaining time.
the solution is really good.