* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
JR Products 541-3-A Black Deluxe Round Electric Cable Hatch with Back

JR Products 541-3-A Black Deluxe Round Electric Cable Hatch with Back

JR Products 541-3-A Black Deluxe Round Electric Cable Hatch with Back
$ 8.21

Score By Feature

Based on 3,749 ratings
Easy to install
9.50
Value for money
9.08
Sturdiness
9.13

OveReview Final Score

How Our Score Is Calculated

Product Description

A hinge that is as strong as any
Both 30 and 50 Amp cords can be used for the vermin door
It is designed to replace any round hatch up to 4-1/2 inches in diameter
A snap lock is built into the door
Diameter of the cutout 3 1/2 inches Outside Dimension 5-1/8 inches Depth of the collar 2-7/8 inches

Questions & Answers

Are you sure the part you insert into the camper wall is of the correct diameter? Can you also tell me the distance between screws?

The round hatch can be replaced by any round hatch up to four inches The outside diameter of the half inch is Diameter of the inner cup 1/8"
A chord length of 3 inches is expected between the holes based on the 1/4"*br>dimensions. The number five. This trailer is currently in storage in preparation for winter.

What is the fit of this for a Jayco 12A?

It is universal, as far as I am concerned. All should be able to wear it.

How deep is the cut and when it's completed, what will it look like? One of the ones I want to replace has a 3' cut out and goes in 1 3/4 inches. ?

Three days of the week There is no reason why the actual diameter of the hole should not be true. Also, the actual possible depth of the cord cavity compartment in the camper should be more than 1 3/4 inches, which means the JR Products 541- is incorrect. There should be no problem fitting A.

When the lid is closed, how much depth does the cover have between the lid and the back?

Although I don't know exactly what it is, I believe it is an exact replacement for my Fleetwood/Coleman pop-up.

Selected User Reviews For JR Products 541-3-A Black Deluxe Round Electric Cable Hatch with Back

The garage wall can be connected to the EV cable hatch
5/5

The cable I needed to pass behind the garage wall to get to my EV charge station was just a simple hatch. In order to pass through the large plug, I cut off the back of the plug (inside). The best option is the simple one.

Rosemary Bullock
Rosemary Bullock
| May 14, 2021
It is an improvement over the original equipment
5/5

My older Jayco PopUp camper had worn out old ones like these, so I purchased two of those to replace them. Both the gas line for the outdoor stove area and the power cord outlet can be fitted with these. If they are broken, you need to replace them timely because water WILL find its way into your camper and ruin it. I love how well they fit! I used the same size hole as my old ones and actually went a little bigger on the outside diameter than the old ones, which makes for a cleaner looking repair and provides more room to putty tape around the hole. The putty tape you will need is available at any hardware store. Almost any hardware store will have some. You do the same thing when you install your windows on your mobile home. The hinge plastic is thicker than what came on the camper, and the awnings are a better quality than what came on the camper. With water unable to get into the "old girl" any longer, I'm sure I will have a lot of fun with it.

Virginia BIRCH
Virginia BIRCH
| Nov 14, 2020
I fitted it to a 2001 Coleman Taos without any problems
5/5

The hatch on my 2001 Coleman Taos was broken, and this one replaced it. Our original ring fits perfectly on the inside, but the outer ring measures about 1 inch larger. The original was secured with three self drilling screws, so I slightly rotated this one and screwed it in place. My rear ring had to be replaced because I forgot to add butyl tape to seal it and keep water out. The rest of the gear fit fine except for the rear ring.

Talia Lawrence
Talia Lawrence
| Aug 12, 2020
It really isn't as big as it looks, but I was able to make As a member of the 50-plus club, I bought this book as part of my week-long book celebration The garage will be installed with an amp circuit to support my electric car
4/5

With a detached garage, I live in a home that is over 100 years old in midtown. The better option is to dig a 3-foot deep hole My backyard required me to dig a 250-ft trench, including tearing up my patio, so I choose instead to purchase a 100-foot wide gutter To run an RV extension cord to my garage, I need a 100-foot extension cable. As a result, I bored a hole behind the gutters on the underside of the overhanging roof in order to avoid cutting a hole in the cinderblock walls. While I found the right part to plug the hole, I first protected the hole with steel wool to deter rodents from walking into it. In my quest for cable organization solutions, as well as other plugs, grommets, hatches, and what have you, I eventually found There is a claim that it is That was the size of the female plug I had to fit through it, so my wire had to be 5" in diameter. The measurement is not completely accurate due to the construction and the vermin door, but it is adequate for its purpose. Approximately every 50 to 60 days There was an L-shaped cord on the amp I looked at Having been designed to support a 50-mm plug end, beware, this hook does not support such plugs It is called an amp cord. As a result, I had to modify the part in order for it to The only way to stretch the extension cord through the hatch would be with my brand new and therefore sufficiently sharp garden sheers. Therefore, I cut into the hatch along one side with my garden sheers, allowing me to bend the vermin door open just enough to squeeze my The part proved to be quite robust, so that it stood up well to The cut I made around the hatch in the soffit did not affect the overall effectiveness of the solution once it was plugged into the hole. The steel wool was left around the cable hatch just in case. I screwed the hatch to the soffit and then closed the hatch, which fit snugly into place. A one-stop shop - Because of the misleading dimensions and fit claims, and the extra work I had to do to modify the hatch to meet my needs, I deducted a star. am not sure what the intended purpose is for this particular part in an RV application, but if you are planning to modify your garage to accept an EV extension cord, this may be able to do the trick. It might be a good idea to find a hatch with a larger opening.

Violette Ochoa
Violette Ochoa
| Apr 18, 2021
Replacing is great, but it can only be used for one thing
4/5

Tent trailers of yesterday are extremely old compared to the ones of Isn't it far better to buy a new one and take out a loan for In order to do that, we look for ways to improve or to change, and this piece was an ideal choice. I removed the old one which was very dry when I removed it, and it crumbled when I removed it. It is an exact match for the one it is replacing. This company hopefully will continue to sell them over time as the plastic will dry out over time. Although the part does not come with a new foam gasket, it does have one downside. There used to be a foam piece in my old one, but I can't find it in this one. Can we possibly do that In all other respects, this piece fit perfectly. Just look at the specs and the measurements and you'll find a good match for this piece.

Mekhi Riggs
Mekhi Riggs
| Dec 30, 2020
Among the most common brands used by It came on my trailer as an OEM part
5/5

In the end, I decided to go with a Marinco detached cable instead, since I purchased this to replace the original hatch cover In a nutshell,.

Catherine Barrera
Catherine Barrera
| Apr 10, 2021
I am writing a post called "RAT BLOCKER"
4/5

My water hose and climbing pole were used to gain entry into the water compartment, which led me to believe the rat had got into the basement after I found and killed a HUGE rat in my basement storage. The device just pops in place and BAM, rats are no more. Upon closer inspection, it appears there are two screw holes where it can be permanently attached, but so far just dropping it in has worked fine.

Liberty Cardenas
Liberty Cardenas
| Aug 10, 2020
It's nice to see the Well-made and sturdy, this cover offers a good amount of protection
4/5

As soon as the 30A cord is pushed in, the cover snaps shut. There is a 2016 Scamp and the pre-amp needs to be enlarged In order for the cover to fit, the hole must be enlarged by an eighth inch. 3 rivets under the old cover had to be drilled out prior to removal. As you can see in the cover, there is no need to disconnect the 30A cable, as the plug wiggles through the back hole. The installation would have been easier if butyl tape had been included. In order to install the cover, 1/8 inch-long 3/16 inch long aluminum rivets were used.

Sloan Cheng
Sloan Cheng
| Jun 05, 2021

Related Products For JR Products 541-3-A Black Deluxe Round Electric Cable Hatch with Back