Manufacturers' Select ITC Fontana Exterior Shower Box Kit Faucet with Shower Head
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The installation was very simple as I replaced an existing shower unit, so all I had to do was connect 2 water lines (ensure hot water is connected to hot faucet) then 4 nuts to hold the unit into place. First time installation would be more complicated.
This picture has an outside dimension of A5 (width) x 5 inches. There are 875 stories (height) in this building. In this case, the number 5 is appropriate. There is an 8-inch cutout in the 125" (deep) hole. The dimensions are 875" (width) x 4". The height of the laptop is 25 inches (height). Thanks, Kevin A team that deals with commerce
I had to replace the one on my boat with the exact same part.
A lever is located on the back of the shower head for turning it on and off
Selected User Reviews For Manufacturers' Select ITC Fontana Exterior Shower Box Kit Faucet with Shower Head
My choice was the locking model, an upgrade from our older sundevastated non locker model. I purchased two keys to go with the product that fit exactly into the old hole. There were electronic instructions available through the item's website. The item included the following A shower assembly consists of a hose, shower head, valves, and box.
We are replacing the box kit that comes with the 19 Tab 320 with this one. A simple swap in and out was all that was required. "Factory installed" is the best way to describe the finished job. This shower hose could be longer, and the box could be a bit better built. I learned the lesson of having to replace it that it is recommended to empty water thoroughly from the hose and the unit before storing it for the winter. Drain all the water from the shower hose after taking off the shower head. In addition, it is helpful if you open both valves and let all the water drain from the trailer's inside supply line.
A replacement for an outdoor shower on my travel trailer, this is an exact replacement. The design of the shower hose causes it to kink and pull at the connection, so I would have given it a five star rating if I hadn't had this issue. Those problems are to blame for the leak in the original installation of the pipe. A 90 degree elbow is the ideal connection, as it allows the hose to lay straight instead of curving. It is possible that mine does not offer enough clearance for the hose to work properly and I am not sure whether the issue is caused by other travel trailers.
We had a lot of trouble with the plastic cover after it was exposed to sunlight for several years. I had not noticed this before, but I noticed the yellow color of the camper's back, which had apparently weathered the sun much better than the front. Installed a new shower after replacing a leaky one Leaks in the head caused it to leak once before. With a little butyl tape and caulk, you can easily remove/replace the seal. So far there have been no leaks, so the system works fine. It will have to be repeated again in a few years as the sun is not friendly to the cover.
A 50-cent coin could be used as the shower head. Although I saw that it was small, I thought it must have a lot of water pressure, considering how small it is. This is incorrect. There wasn't much pressure put out by it. . . If you tried to shower with it, you'd have a hard time. This product is not supplied with a hanger to hang it from so you can use it The price is way too high! As you can see, we have to swap out the shower head in order to get a nice flow of water, and you can see we used a command broom holder to mount the shower head. Additionally, there was no instruction or template to be able to cut out a hole to install the product. searched online and found it on our own. This is the most disappointing thing I have ever experienced.
Our old shower was given to my husband, and he used the information to find this one. Neither the screw holes are out of alignment nor are they too close together. A few things bother me, however, such as the lack of a clip for securing the shower head. It was a blessing to still have our old one. If only we knew how to swap them.
Because it is assembled, all you have to do is hook up the shower hose, I found it to be extremely useful and worth the price.