Motive Gear GM10-411 Ring and Pinion (GM 8.5" & 8.6" Style, 4.11 Ratio)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is the case, but I would replace the g80 with a Detroit Truetrac before it failed and ate
There is a GM 9 in your possession. The last time we saw gears for your application was 15 years ago, so we still don't have any new gears. There is a bearing installation kit #R8 that we have in stock. I have nothing new or used on the ring and pinion but 4RMK. I thank you for your kind words
Camaros with the 10 bolt 8 will have the 80 Camaro. There is a gear that will fit this rear axle and this rear axle. In the event that your stock ratio is not 3, you should know what it is. In this case, there are 8 bolts instead of 10. A carrier change occurs at 2 for 5 at 5. It is 72 and higher in numerical terms. If you are below two numerically, it means you are too low. If you change carriers, you will need to change your number. I thank you for your contribution
The grade for this is Gears with five 10-bolt holes
Selected User Reviews For Motive Gear GM10-411 Ring and Pinion (GM 8.5" & 8.6" Style, 4.11 Ratio)
It is a good quality gear set that is reasonably priced. The 10 bolt 8 tube I put into my 99 square body suburban worked great. The number five. I previously replaced the ring and pinion on my truck before I took possession of This was installed incorrectly because the installer did not clean out the chunks from whatever bearing came loose earlier which caused the inner pinion bearings to wear out (as well as the spider gears), but nobody cared and the motor was driven anyways. It didn't seem to matter what I did to replace the bearings or clean everything if I still couldn't After buying this set, I wiped my hands clean of that set. I was very pleased with how easy the setup process was. Then I used a straight edge across the mounting flats of the carrier bearing cap mounting cap to measure the pinion depth, and then I adjusted the shims a few times to compensate for the ring gear backlash, checked pattern, and it worked perfectly. After I constructed it, my differential is again noise free. I've owned this car for over a decade now, but this is the first time in my ownership that it's quiet.
The 73rd and 4th instructions must be followed. The number 11 goes with the number A 73 for wheels 20 inches in diameter. My project is going well so far. I will update you in a year or sooner if something happens.
It would have been better for me if I had I will never buy this brand of gears again after running them for a couple of months on my truck there was too much noise. I am going to put in original gears instead.
I will give you my two The truck is very fast in 43 first gear!.
I'm super.
Gears are of the highest quality and run quietly. The order was shipped quickly, and I'd buy from them again if needed.