Design Engineering 010230 Ultra Sheath MA Lightweight Extreme Heat Protection for Hoses, Fuel Lines & Electrical Wiring, 0.5" x 3'

Used contrary to its intended purpose It was less than half an inch from the 2" Radiator return hose to the header collector for header #1. We wrapped the header to reduce the air gap and we used a 9" section of this sheathing to cover the hose (unfortunately, they don't have this sheathing in 2"). Sheathing is great, and the piping stays cool on the other side. I was able to remove the stitching once I got it cut without causing damage to It is very clear that the sheathing has been held in place for the last two The radials are on the same side, and it is in good condition.

Kelsey Maldonado

| Apr 17, 2021

I like it.

Rosalee Clements

| Apr 28, 2021

There is a tendency for this to fall There was not a lot of stitching and it was tearing apart. I was sleeving my fuel line and it was the non stitched side that tore. I had to cover it with a I wouldn't recommend it because it's a waste of money.

Banks Buchanan

| Jun 27, 2021

Sliding and adjusting the sleeves is accomplished by pulling and pulling from the center. The product is manufactured in the United States.

Alani Allen

| May 30, 2021

This is a nice product.

Watson Roberson

| Oct 23, 2020

The material is cheap, so it easily rips.

Remi Merritt

| Aug 30, 2020