Mr. Gasket Screw-in R/Arm Studs 3/8" 16Pc, Black

$ 49.37

Score By Feature

Based on 3 ratings

Packaging

8.99

Satisfaction

8.42

Value for money

8.53

Giftable

8.99

OveReview Final Score

How Our Score Is Calculated

Product Description

A black oxide coating is applied to grade 8 steel

16 Studs are included in the kit

Iron and steel heated to a high temperature

The software is easy to install

Designed to last for a long time

Suitable for vehicles with the following fit types

Questions & Answers

The only thing that needs to be done with these studs is to tap the holes for the screws 7/16-inch Since the stud bosses will not have to be machined like with other screw-in studs, I won't need to do anything special What do you mean by "in studs"?

Yes, that is still the case. Guide plates will not be able to be run

It is not working for my application as per the Fitment Verification. What model is it? Is it a 1970 Chevy Sportvan with a ?

Unlike a vehicle specific product, this is not made for specific vehicles. This is the product information Compatible with Honda Accord - 265 The rocker arm is threaded 3/8 inches - 400*br> • 24*Screw - (IN) In Depth The standard thread size is 7/16 inches per inch. There are 14*br>Qantity There are 16 pieces in this set

The dimensions of the item are what?

The threads on the base are 7/16-inch. The diameter of the tubing is 14 inches. This is the thread size for rocker arm nuts 3/8" - 38 It is 24 inches wide. The guideplate location shank is as follows Nylon thread length (inches) of the rocker arm nut is There are 916 inches Inches of Effective Stud Length (In) I am 470 inches tall. This thread is of the following dimensions Thread Length (ins) The width of the tile is 868 inches. This quantity is These 16 cards are sold as a set.

Selected User Reviews For Mr. Gasket Screw-in R/Arm Studs 3/8" 16Pc, Black

Screw installation was simple and easy, but it had to be done by hand

5/5

We still don't understand why GM used to press in studs. That would be a pain in There was no good way to tighten them except with a pair of vise grips and a lot of locktight! The installation instructions were easy and the screws were quick to install, but it wasn't easy to tighten them. Additionally, if you do not take care, you may get gall on the smooth part of the stud, where the rocker arm is located, and that would be problematic. This part is perfectly suited for installing on an engine that is still running, as it has a hex or square collar that is smaller and rounder than what is normally seen. In any case, it is a good product!.