AED 4150 Ultimate Holley Double Pumper Carburetor Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is a spread bore carb, so most of your parts will fit except the base gaskets and throttle plate gaskets, other than that, you will find many standard holly parts to fit.
Despite the name change, the 76751 stays essentially the same as the If you are trying to save weight, then I would answer yes to that question. Use caution when removing old gaskets, and do not gouge the alum.
You may replace gaskets if you have cleaned your carb and want to replace the seals. If you want to match the PV and the jets and ect., you will need to buy the
Selected User Reviews For AED 4150 Ultimate Holley Double Pumper Carburetor Kit
A 4779-based computer was completely rebuilt by me The 9 4150 holley 750 double pumper has been discontinued. included all the hardware parts, and it went together without any problems, however, it was short on gaskets for the float adjusting screws and the filters that connect the fuel lines. As the kit is a universal kit for several variations of the 4150 carburetor, it came with plenty of extra nylon and paper gaskets, but supplying the float adjusters and new screws and nut without providing the necessary gaskets seems absurd to me. There is no gasket that fits, so I'll have to buy one or make one. Taking out the old software after a fresh rebuild would not be beneficial.
I guess you can try your luck again next time? After rebuilding my Holley 650 with this kit, I was pleased with the results. There were none of these seals, needle seals, or bowling mounting hardware seals in this kit. The staff at AED provided me with a prompt and courteous response, and mailed me all the parts I You follow through so well,.
Apart from that, everything else is fine. The situation is fine.
It was rotten and the plugs for the accelerator pump were damaged. These screws didn't come with the round cork gaskets for the air idle screws, and I had to buy new ones.
The hair blow dryer is all what's needed to help those having difficulties with the vacuum seal. You can pass the plastic on low a few times to soften it.
There were a lot of pieces in this kit, but we never used them all.