Injector Basket Filter or Micro Filter Removal Tool (+Optional Basket Filters)

Injector Basket Filter or Micro Filter Removal Tool (+Optional Basket Filters)

$ 9.99

Score By Feature

Based on 191 ratings

Accuracy

7.76

Value for money

7.11

Comfort

6.76

Easy to hold

5.86

Ergonomic

6.06

Quality of material

5.89

OveReview Final Score

How Our Score Is Calculated

Product Description

When removing filters from fuel injectors and performing rebuilds, the best tool to use is an air compressor.

Any type of fuel injector filter installed on the top or side of the engine should be taken out

This tool screwed easily into the basket filter and it was easily removed by turning the knob

The bottom of the filters is equipped with a rotating mechanism that enables easy removal of the filters / baskets from the

The US ships its products

Questions & Answers

How do these filters compare with the ones in my 2004 Chevy Silverado?

There is no chance of them doing so

This item will fit this How does a 7l hemi compare to a 6l?

In the event the little baskets are hanging in the injector body, here's my input. There is no way to remove them with this. As a result, it has a short travel time. In my case, they were inside an This is the case, at least. As a result, it would not reach into the corners of the hole to remove and screw the nuts.

Does this filter fit the injectors in my 2004 Infiniti G35?

There is no chance of them doing so

Selected User Reviews For Injector Basket Filter or Micro Filter Removal Tool (+Optional Basket Filters)

Does what it is supposed to! It is my pleasure to assist you with repairing the fuel injectors on your By using this little tool, I was able to pull out the filters inside As this tool did not require a vice, I did not have one

5/5

There is a certain amount of elbow grease involved in taking the filters out, but it is certainly doable. You'd be able to do it much faster if you had a vice. Rather than extending the screw all the way out, it's better to screw the injector onto the tool before extending the screw. Once that was done, I screwed the handle back down until it was almost on the injector, then started pulling hard. Just wiggle it a little while pulling, and it will eventually move.

Jamie Curtis

| Aug 05, 2020

Exactly what I needed

5/5

I am satisfied with the results It is simple to remove the old filter using this tool. I was able to press on the new filters easily and they fit well.

Harleigh Park

| May 01, 2021

Would have been better if the outcome was different

3/5

Did the job, but was barely able to do it. My plastic washers that are on top of the inhectors and cannot be replaced are bent. To make it fit snugly, they could have made the gap between the rings a millimeter or two smaller.