Thermo-Tec 14110 48" X 48" Cool-It Mat

On the entire floor, I applied POR15 after I had prepared it. On top of that, I applied sound deadening material (similar to dynamat) to about 8 square feet of the room. In the next step, I laid the Thermo-Kote floorboards on 75% of the floorboards Tape 3M Foil down to secure the component together and use a hi-vis tape to secure it to the chassis To secure it to the floor, use temp spray adhesive. I was able to cut the fabric with a pair of scissors easily. There was a continuous sheet of vinyl running along the entire floorboard of my Mustang. It was hard for me to decide whether to re-admit Replace the old carpet matting with the new carpet or lay the carpet directly on top of the thermo-plastic This is technology. After evaluating the situation, I decided that it would not harm to replace the carpet matting. When reinstalling the seats, I had one issue with the thickness of all the pieces, however, it was not a major concern. Due to the fact that I didn't punch holes in thermotec while I was installing it (holes for the seats and seat belts, etc. ) it was a lot more challenging to match up the holes. Initially, the assessment is as follows There is much more cool air in the room now than there was before. The carpet was warm before I felt the heat coming from the floorboard. Almost all of the cases have been It is true that the weather has changed dramatically and it has become much cooler here in Georgia, but I would consider the difference to be considerable. The two 48" x 48" mats and two 24" x 48" mats were more than enough to cover the entire floorboard ('67 Mustang coupe) with some It was simple to use one roll of foil tape measuring 2" x 50 yds. In general, it is a good product. Just be sure not to skip over.

Emma Ramirez

| Nov 02, 2020

During driving, excessive heat from the motor compartment can cause the interior of the RV to heat up. I purchased this product to help with this problem. As a result of using this product, no difference was observed. The cost of the two was $68, so I bought two. I would have ended up losing $136 if I would have bought two for $48 each. It cost 96 dollars plus the cost of adhesive material and roller applicators, and we had to spend a considerable amount of time installing.

Joshua Palmer

| Dec 09, 2020

In the end, it met the needs of the organization.

Atlas Schmidt

| May 18, 2021

You're doing good work. I used it to insulate my Cerakote oven and it works fine.

Eliezer Lopez

| May 15, 2021

The product is great.

Adam Morrow

| Apr 14, 2021