Rexka 50pcs Fender Flare Bumper Door Trim Plastic Rivet Retainer 1/4 Hole Compatible with Chrysler 6506007AA 07-20 Jeep Wrangler, Wrangler Unlimited JK & 02-12 Liberty KJ GM 10184895 Ford N803862-S

Although they look the same as the Dodge, Ram, or Jeep ones, they perform worse. It takes longer than usual for stems to break off, or they don't break off at all in some cases. Since the real ones are outrageously expensive and harder to come by, these are likely an acceptable substitution for most people, just be aware that you'll probably have to trim the stems.

Brian Foster

| May 18, 2021

My 2011 fender was broken in a few places, so I ordered these to replace some of the rivers that connected the inner lining to the outer lining. There are fewer of them (the head and washer) than the factory ones and they can't be used on I went to harbor freight to purchase the rivet tool, and they sell a set for $18 that comes with 4 different rivet sizes (one of which was the exact same size as the factory rivet). If I had known that information beforehand, I would not have chosen.

Kadence Cooke

| Apr 11, 2021

You should be aware that the head size is smaller than OEM if you are using the product on a Jeep or Chrysler. While they are worth a great deal and appear to be well made, they differ in some ways. The first time I used 4 on my Grand Cherokee's fender flares, I thought it was better than 3. It is not a big deal or worth the effort to pull them out, but I wish I had noticed before installation.

Karsyn BUTCHER

| Sep 18, 2020

I'll take 50 of each, ha ha ha! After doing some work behind the wheel well of my 2018 JL Wrangler, I needed around 20 of them. As with the OEM, these are the same.

Rylee Alexander

| Mar 07, 2021

Rivit components are identical to those used by OEMs. There is a $3 charge from the dealership. I was shocked to hear they were being charged 50 each. There was a need to purchase a different riveter for these plastic rivets, but I found one at Harbor Fright that was not expensive and I bought this for a great price!.

Nikolai Waller

| Nov 17, 2020

I'm going to widen the holes just a bit. Nevertheless, it worked as expected, just make sure that you have a plastic rivet tool.

Molly Hendricks

| Nov 29, 2020

My 2014 Grand Cherokee was not an exact match for these, but they did the job. I also had to purchase the special pot rivet tool made for plastic rivets for a very long time.

Cali Best

| Jun 28, 2021

A rivet with this small diameter won't fit under Jeep fender liners and its shoulders are thin compared to Jeep parts, so it won't fit snugly under Jeep fender liners. The quality of your purchase is determined by the price you pay.

Serena Marquez

| May 24, 2021