Hooke Road Wrangler JK Steel Flat Fender Flares Front & Rear Mud Guards Compatible with Jeep Wrangler JK & Unlimited 2007-2018 - Set

In order to order this drill bit, you must order it in 11mm. Neither Virginians nor people in other states have access to It takes about 15 minutes per side for the front. The rear took almost as long. I ended up using a 7/16 bit and JB weld. Although I’d liked them, it would have been nice if they sent a drill bit or used common.

Lucy NAYLOR

| Oct 04, 2020

The frames installed okay, and the finish was good, but after three weeks on the Jeep, the rust has already begun to cause the powder coating to bubble and peel off the frames. EDIT

It seemed that I could sand the rust and bubbled paint away and then paint them again. Since they were rusted before they were painted, I expect it to be much more difficult than I expected. As I use my abrasion wheel, I'm finding more and more rust. I've attached a new picture to illustrate this point. The third time I unpacked these is 3 weeks ago. The shoes should not have been bought.

Colby Norman

| Dec 27, 2020

dislike about them is that there is not enough mounting hardware, but other than that they are excellent.

Harlan Cortez

| Sep 13, 2020

Wrapped in foam, the stickers were delivered. I took the time to really smooth out both Wrangler stickers. It had to be redone After smoothing them out, you can still tell they are in order. The sticker has two sides, one with wax paper and one with sticky adhesive, so you need to try to get the thin sticker to stick to the wax paper side and not the sticky side before you apply it to your Jeep The second side had a wrinkle in the W from the shipping - I was only able to get one side. Although I tried, the C sticker did not stick to the wax side. With all the thin stickers used, the C sticker simply would not stick. I tried several attempts to fix it, but it went haywire.

Brian Peters

| Dec 25, 2020

The box was damaged when I received it, and the fenders were damaged on the corners. Installation was fast because I already removed my stock fenders, but I was not impressed It would have been better if they had been protected The description refers to using factory holes and no drilling, however you will need to drill the rear holes.

Paola Raymond

| Jan 25, 2021

I had a difficult time installing these. There were a few adjustments I had to make. I like the way they look and feel when they are installed.

Rosalia Wiley

| Mar 07, 2021

A very good value when it comes to fenders. Pay attention to what you are doing when you install and do not get ahead of yourself. there is anything you don't understand, please ask someone, because you are making the difference between an unsecured fender and a tight,.

Brynleigh Santiago

| Feb 26, 2021