Lantee 10 Pcs Engine Under Cover Push-Type Retainer Clips for Toyota & Lexus 90467-07201
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
That's what they should do. I have a 2007 Lexus IS 350 that should fit them
Originally purchased for a 2008 Lexus RX350, I used this retainer. The Lexus uses only one of them for its engine cover. Hole diameter is 7mm, and this retainer fits a hole of that size.
Assuming it fits on the 3010 GS300, I can only assume it would work on any 3010. Though the size is a little smaller than I would have expected,
In my opinion, they work for most Toyota products.
Selected User Reviews For Lantee 10 Pcs Engine Under Cover Push-Type Retainer Clips for Toyota & Lexus 90467-07201
When the Lexus HS250H was originally released, the retainer clips could instantly be released by pushing this in and activating this. Then these aren't the ones. In the bullets I was not informed that I would need to purchase a removal tool, which is needed in order to remove them from the frames. To understand the entire text, you must read it all. Is that so? What are the retention clips for? I gave them two stars since they work, but not as well as the originals.
Lexus engine splash shield (P/N 51440) should be attached with the correct parts. These are not the correct parts. 51453 fits exactly into the 13mm diameter hole in the frame and can be easily installed. The purpose of these is not clear to me.
The Lexus brand. It takes no time at all to install the clips and remove them. They are a perfect replacement for the ones that the Lexus dealership's service mechanics forget or refuse to replace.
In addition to replacing all the original clips, I have enough left over to upgrade to the Toyota brand. I feel these clips are stronger and less expensive than the Toyota brand.
It is a good thing I found them.
There have been some reviews stating that only the OEM clips open up if you push down (easier) and does not require a pry tool to lift them up to open up. As far as I remember, I did not press down on the button to see if it released the lock. A small screwdriver is all you need to pick up the whole assembly, I just gently lifted the button a few millimeters. The system is easy to set up, to uninstall, and to I do not believe there is a need to acquire more expensive OEM components.
The cloth under the hood of our 2006 Corolla had to be pulled out.
It fits perfectly but has an aftermarket look.
Related Products For Lantee 10 Pcs Engine Under Cover Push-Type Retainer Clips for Toyota & Lexus 90467-07201
