Auto Ventshade AVS 77005 Windflector Classic Universal Sun Roof Wind Deflector fits up to 41.5in. Wide Sunroof

The 2014 Jeep Liberty has been reduced in wind noise by the new shield. From edge to edge, the hat fits perfectly. Installation takes less than a minute.

Miles Robinson

| Apr 11, 2021

Currently, my Jeep Liberty 2009 comes with a Sky-Mount system The sliding door makes a lot of wind noise at speeds over 55 miles per hour, even if It is said that the Windflector will reduce noise on the sun roof, but they do not offer one for the Sky-roof Animated sliding panel. One of the largest Winflectors is this one, with a diameter of The fifth point is 5. As soon as it arrived, it was damaged about 12" from the end, so I asked them to send a new one, if I could keep the damaged After I sent them my old one, they told me I would be credited the amount that I paid ($34), I didn't have to return it, and I could order another one in the future if I wanted. In order to check the old one against the current size needed, I compared it to the old one on You are viewing the slider for The number I need is According to how the instructions state to measure it, it is 5" long. As a result, I thought there might be a way to cut each half in half with an extra inch on each side so it would fit when In order to purchase the new Windflector, it is now $43 - but at this time, it is almost sold out. In any case, I ordered it. As soon as I received it, it was in good condition, so I put it on the vehicle to determine how well it fits. 41 years of age. When the sky is 5 feet tall, it will not go over the front edge- I could tell it was going to hit the top of the sky when it slid the farthest- As far as I can tell, there will be no choice but to mount the slider further away from In addition, the curved part was too thin for the roof of the vehicle, but it looked as though it might bend enough to fit The product is 5" long and does not have to be cut. with the slider open on both ends, as well as closed as best I could. I mounted it then. After being pulled down on the edges, the center of the sphere was over the sky Sky-slider is no longer in contact with Sky-slider is raised so that it no longer touches or rubs against Sky-slider Animated sliding panel. The pictures are beautiful! Additionally, when I went to install it, I totally forgot about using alcohol to clean it. The roof of the car needs to be cleaned off the seal adhesive area with sticky pads. My first thought was I had blown the installation, but it seems that the roof was clean enough since it is still holding up. The Windflector has been installed on the car now for a couple of weeks in very high temperatures (like 105 degrees F) and has shown a good performance In the heat (200 miles or so), the car has not been much used in the sun but it has been driven some. wind noise has been reduced quite a bit, although it is still audible at 55 mph. While it still drowns out the radio, it no longer drowns out the traffic. The Sky needs to be sprayed with silicone spray - There is a seal on the slider. Windflectors work for me, and I recommend them. I also have another broken one to work with in case I need to redesign it. My car has been driven many times at 70 mph (and slower), in bad weather, in hot weather, etc. , towed for 2500 miles behind our truck, and it has held up fine. I forgot to clean it when I installed the product. However, the car was clean and the sealant attached nicely. A spot has released a little bit of the seal and a piece of it is missing during installation, but that is normal. I wonder if it was on purpose that the piece was missing. In any event I am pleased with how things are going so far.

Ricardo Ho

| Jan 23, 2021

The following is a translation of the Greek text I would not recommend buying a 2017 Ford F150. I don't think it will work. On my roof, there is a plastic peace that obstructs my view. It is possible that I will have to pay shipping and a restocking fee if I return the item. That is not right since I was told that it would fit for my truck when I bought it. In order to retrofit the shield to fit around the plastic peace on the roof, I will try to do a jigsaw puzzle.
After a few minor grinds, I got it to fit. Here is a video to check out.

Roy Walter

| Apr 03, 2021

In the title it states that it was a hit on our 2010 expedition. Unlike some, I did not have to trim for the satellite radio receiver and the paint stuck to the satellite radio receiver perfectly. I don't mind that it is wider than the sun roof it does not concern me. The product looks nice and does the job it's supposed to do. If I had to buy it again, I would. This is a *br*br*t.

Remington Stevens

| Nov 23, 2020

The year is 2008 A look ahead to 2020 It was expected that the performance would be much better, This is not the case. This is how the wind feels I would prefer a quieter profile, but the noise is too high. A sudden vertical angle is seen on the front. Looks at on-the-ground conditions Air is on its way. Aside from that, all four windows have been completed. When the fronts are fully closed, they whistle a bit. The number 11 is the eleventh of May In 2019, we will Changes things for the better.

Kye FitzGerald

| May 25, 2021

46 is not the dimensions. It is reported to be 9 inches in length. Having a width of 43 is not enough. Contributes to the success of a project. There are almost 41 cubic feet of interior space.

Oaklynn Walsh

| Dec 29, 2020

To accommodate the satellite receiver, you will have to notch the back by a half inch. You will not be able to get any adhesive in this section if you go any further. Getting this effect takes a little patience, but the final result results in a really nice look and noise-reduction on the moonroof.

Leonel Chambers

| Jan 10, 2021