LTI 10 Feet Length Universal 3mm (1/8 Inch) Inner Diameter High Performance Silicone Vacuum Hose Line (3MM, BLUE)
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For LTI 10 Feet Length Universal 3mm (1/8 Inch) Inner Diameter High Performance Silicone Vacuum Hose Line (3MM, BLUE)
The EVAP system is not spelled out for this hose, but it can be used in the process. This silicone product can withstand the heat under the hood in the engine compartment due to its high temperature resistance. There is a problem with the hose that I am There is a thick hose attached to the tank- There are enough walls compared to the outside air pressure for the lower pressure inside to be handled. A pressure of 999 bar is equal to 14 psi. Also, I need accuracy in the inner diameter of this hose since I will apply it for a special purpose.
My 2008 Saab 9 had old, dried out vacuume hoses that needed to be replaced The following are the five points 1. With these 4mm blue silicone hoses, 3T will be able to handle any task. I zip tied the longer lengths as originals weren't clamped on, so they fit snugly in place on the engine. I did not clamp them onto the ports as originals weren't clamped, but they look neat in place. In the event that clamps are required at the connection ports, I will inspect them as I age them. The YouTube videos on how the job should be done showed me the right way to go. The product worked very well and I would recommend it to any vehicle that is similar.
The hose I received was much larger than advertised, which is important in rare use cases such as vacuum lines on turbocharged engines. The item could be returned, but I would have to pay for shipping back, which would be an amount comparable to the cost of the item. However, it is stretchy and will fit over larger fittings with a fair amount of force, so I plan on using it on other cars later on. **As a side note, I ordered 10mm at the same time and it fits just fine as well.
Heat resistance is a characteristic of the tubing, which is of good quality. This product came very clean and in an outer plastic bag to ensure it was protected from outside circumstances. For a project in the automotive industry, the vacuum lines were used as part of a PCV vacuum line and brake booster lines.
A few engine vacuum lines as well as windshield washer lines had to be replaced. tube is perfect for the vacuum lines in the engine, but the OD is too large to reach where the washer lines used to run.
A clamp can pierce it with ease. Melts in high heat, milts in gas, and seeps through gas. The vacuum line is only meant to be used for vacuuming.
It was a great deal and plenty of tubing for the money, I needed some for my truck. I was able to accomplish what I wanted with this.