GM Genuine Parts 24243353 Blue Half-Shaft Seal
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I think it fits the driver's side of the car.
All 4T65E transmissions (left, drivers' side, CV joint) should be compatible with the seal.
There is no need to replace the passenger side seal for the RH.
The seal has a diameter that matches the diameter of the large socket I used to install it. Take your time, drive an even line into it and you should not have a leak. I have used this method on many jobs with no problems.
Selected User Reviews For GM Genuine Parts 24243353 Blue Half-Shaft Seal
My hub arrived in good shape on time. However, the mounting flange is slightly thicker or the stud heads of the lug nuts on the hub are thicker than they were on Using the OEM washers was no longer possible since this caused the mounting bolts to hit the lug nut studs and prevent the hub from turning. If the washers were removed, there was enough space for the hub to freely rotate. It was bent instead so as not to rub the front surface of the rotor, because this caused the dust cover to rub it. The bolts were to be ground down and the heads were to be ground down. I opted to leave the washers off for fear the bolts would become weak. As far as I know, it works fine other than what was mentioned.
I have installed my new Heri HD axle and Timken USA made wheel hub along with my new Heri HD axle. This is an excellent product. As a seating device, I used a Compressor pipe "cap". You're not going to get much out of seal "set" tools unless you spend lots of money You can visit Home Depot and find a cap with the same diameter as the old seal, and then you can forget about Harbor Freight on that tool. I had no problems with it.
This system failed to seal the axel transmission fluid seeping out every night. It was replaced with a brand that did work. This is ACDelco, you need to get organized. 2005 Pontiac Montana WRC.
I am extremely impressed with the You must paint the bottom to remove the old gasket, but the new one works seamlessly once the old one has been removed.
Although it is a pain to drive into because of the location, and I had to buy a metal pipe fitting to break the hammer on it because of the location, it's adequate.
The mirrors are mounted on the passenger side of a The driver's side of any GM 4T65E transmission will work with this adapter.
Whenever you replace the shaft seal on the cv, you should also replace the ball It is important to understand that the seals on the driver and passenger sides differ. Therefore, do not order two of them at the same time.
Replacement that works great.