Genuine Ford F3TZ-3517-A Bearing

$ 7.00

Score By Feature

Based on 66 ratings

Easy to install

8.51

Value for money

8.53

Sturdiness

7.69

OveReview Final Score

How Our Score Is Calculated

Product Description

Parts manufactured by the original equipment manufacturer

The package measures 8 inches high by 8 inches wide by 8 inches deep. This 482 L x 1 is calculated as follows. A 777H x 7W symbol is used to represent scale. The area measured in W (centimeters) is 874

No weight is attached to the package. The weight of 022 lbs.

The origin of the cynical phrase is

Questions & Answers

I'm looking for a set of a and b bearings for a 1995 ranger tilt steering column. Will these 3517 bearings work?

Thank you for your inquiry, the upper bearing would be the F3TZ3517A and the lower bearing would be the I appreciate your kind words

Do you think it will fit my 1995 Ford F250 ?

ought to lead to all of Ford's pickup trucks in the 90s up until 1997 using I've fitted it to my 96 Ford F350 just fine, however, it is the rear bearing and not the small one in

How do I know if this fits a 95 Ford F150? What should I do when other websites say this is the one? Amazon says it won't work though?

The truth is that I am not sure. It might be best if you talked with someone in the service/part department of a Ford dealership. As an FYI, this part number is actually split into two parts Here are two A's and two B's. On our 93 F-Type, they go to different parts of the steering column

Do I still need any other parts for the repair of a sloppy wheel if I purchase both bearings?

The bearings of a faulty column can sometimes be replaced in order to repair it. Most of the time, however, I find that if the front bearing wears out it can cause deep damages to the alum housing and cause the shaft to get damaged, which will require a replacement. It is possible to need to replace both the pressure sleeve and the spring sleeve. In order to rebuild it yourself, you will be required to remove the gear that is under the lock and tumble, and it will be tricky to put it back together again. Sorry, I do not know the Ford names for any of the parts, I have been doing this for so long that I just call them after what I think they should This may be of some use to you