Yukon Gear & Axle (YMSC1003) Front Inner Replacement Axle Side Seal for Jeep TJ Rubicon Dana 44 Differential

I recently purchased a 1994 Jeep YJ and discovered that the previous owner had installed a 30-inch rim The Dana 30 is equipped with a spline axle shaft kit and OX locker. It was found that the axle seals had been installed incorrectly & Leaks were present. The difference between 27 and 28 is The shafts can be splined to 30 If you need splines, then these seals are what These are also used on TJ Rubicon models as a result of their 30-inch wheels There are spline shafts on the front end of their Dana 44. No matter how hard you look, you will not find the right seals at NAPA or any other The axle disconnect system can be installed in a Dana 30 with the axle disconnect system installed Seals for the axle disconnect window (where the axle shift motor mounts on the axle tube) must be driven into the outboard side of the axle disconnect window. Some 1/4" drive extensions, a hammer, and a wrench were used to pull the car off the wall They will be driven in by my wife. Having a second pair of hands will be necessary for the installation. The seal design is hands-free Installing an axle seal is much easier than you might think.

Everleigh Gardner

| Oct 26, 2020